Shopping Cart

Your cart is empty.

Your cart is empty.

100879 Reedless Flow Switch with Pilot Feature, 3/8in FPT Inlet/Outlet, 5amp,12.0 GPM, 4000 psi

5.0 Write Review
Free shipping on orders over $29.99

$104.99

$ 49 .99 $49.99

In Stock

About this item

  • Product Performance:Flow Rate: 12.0 GPM (maximum), 10.0 GPM (operational).Maximum Pressure: 4000 PSI.Maximum Operating Temperature: 180°F (82°C).
  • Product Features:Electrical Rating: 250 VAC, 5 Amps, Max Switch Voltage: 250 VAC.Resistance with Leads: 30 OHM.Electrical Service Life: 200,000 Cycles; Mechanical Service Life: 10,000,000 Cycles.
  • Note: When using this flow switch in a system with a positive displacement pump, it is recommended to install a safety relief device in the appropriate locations to protect all parts of the system.
  • Installation Instructions:Install the flow switch vertically to the output side of the unloader, with the 2 conductor lead wires exiting from the top. If your system uses a downstream chemical injector, it should be mounted on the output side of the flow switch.
  • Service: This is a aftermarket replacement part, please confirm the compatibility and model numbers before buying. If you have any questions, please contact us through amazon message directly. We will reply within 24 hours to answer the questions.


Product Performance:

  • Flow Rate: 12.0 GPM (maximum), 10.0 GPM (operational)
  • Maximum Pressure: 4000 PSI
  • Maximum Operating Temperature: 180°F (82°C)
  • Electrical Rating: 250 VAC, 5 Amps
  • Max Switch Voltage: 250 VAC
  • Resistance with Leads: 30 OHM
  • Electrical Service Life: 200,000 Cycles
  • Mechanical Service Life: 10,000,000 Cycles

Note: When using this flow switch in a system with a positive displacement pump, it is recommended to install a safety relief device in the appropriate locations to protect all parts of the system.

Installation Instructions:Install the flow switch vertically to the output side of the unloader, with the 2 conductor lead wires exiting from the top.If your system uses a downstream chemical injector, it should be mounted on the output side of the flow switch.

Service: This is a aftermarket replacement part, please confirm the compatibility and model numbers before buying. If you have any questions, please contact us through amazon message directly. We will reply within 24 hours to answer the questions.