Your cart is empty.
Your cart is empty.Product Description
Super mini size
Size: 25*15*4 mm
Super light weight
Weight: 17.9 g
Ready To Go
pre-soldered XT60 & 3.5 mm bullet connectors
Excellent protection
Include protection of start-up, over-load, throttle signal loss & blocking.
BLHeli_S
It can be set up and programmed using the Arduina Nano.
Scope of application
For multi-rotor, FPV, fix-wing, other models and etc.
D3169
2025-08-31 12:38:31
The ESC is lite and can handle 20 amps just what I was looking for. Works perfectly and is a good value for the money. Easy to use I just plugged it in and started flying. Was able to get full speed out of it. Like the small size to. It comes with a XT60 plug and I charged it to fit my batteries.
Customer
2025-08-11 15:27:08
Using these in several pusher prop jets, using 3s in 2200kv outrunners and apc 6x4 pulling 16 amps, works great, really light and small, default settings worked perfect.
Randy Scott
2025-07-29 15:14:48
Great little ESC! Worked right out of the box for 30/40mm EDFs. (calibrate first). Unfortunately the programing instructions are all in Chinese so that is the only reason I gave it 4 stars. They are very small and lightweight compared to most 20amp ESC which is perfect for small lightweight EDFs.
Monster Parts RC
2025-07-22 13:13:54
I needed two of these for a dual EDF 3D-printed, jet and they work great! Their small size and good power handling allowed me to run a 4S lipo on my dual 40mm EDF jet... I would use anything else in this scenario!!
J. Gibson
2025-06-23 15:08:14
Very light weight and well built. The casing can be easily removed without damaging the electronics, which can reduce the weight to 3.7 grams.
Remsen haynes
2025-06-08 19:45:28
One out of the four wasnΓ’β¬β’t any good?
Megan P.
2025-05-19 11:43:20
This receiver is compact and inexpensive so I purchased one for a glider. It works well but first flight I discovered it comes with the brake function turned off which doesnΓ’β¬β’t work well for planes due to added drag when throttle is off. To turn on the brake function requires a Arduino Nano(25 dollars on Amazon), a PC, and BL Helisuite32 firmware downloaded from the internet. Not sure how this qualifies as easily programable. I already replaced the 60 size connector with a 30 and shortened the wires so I couldnΓ’β¬β’t return it so I gave it to a friend who flies drones which this is suitable for.
Pedro D
2025-05-01 14:33:47
Perfect size and weight for a small 3S 1100mah parkflyer. Didn't need fancy programming; plugged in to receiver, hooked up batt and flew perfectly, no issues with this ESC.
John-paul
2025-03-22 11:17:39
Just perfect
Benny
2025-03-01 17:30:35
Der Regler funktioniert gut. Das einzig was fehlt ist eine Bedienungsanleitung.
Gage
2025-02-11 16:52:05
I had no issues setting this up, which i was expecting a bit of a hassle since I have bad luck with drivers for various electronics. I am not overly experienced with this type of ESC, so I'm not sure if they all do this, but i could do without the jingle it plays when you boot it up. Other than this, it works great!
Staar Jean Jacques
2025-01-04 09:22:24
L ESC ne passe pas en 2s .Pleins gaz maxi 30 Watt.
Donalee
2025-01-02 13:47:36
Good quality
Recommended Products
$126.54
$ 61 .99 $61.99
$124.99
$ 53 .99 $53.99