Your cart is empty.
Your cart is empty.Heavy duty. Made in USA of steel with rubber grip handle. One side is a spanner wrench that helps tighten faucets to shanks or towers. The other side is a hex nut wrench which tightens the nut on your keg coupler. A very handy item to have. In stock and ready to ship. Features: Steel with rubber grip. Specs: 7 inches long.
Timothy John Armstrong
2025-06-27 14:38:05
It works perfectly for the set up I am currently using!
Richard Godinez
2025-06-22 14:24:23
Needed to clean and replace my beer faucets needed a wrench to disassemble and have them cleaned. Found this product to be very helpful at a extremely reasonable price. Saved on gas saved on time ordered from home and delivered on time. recommend find this from Amazon.
Peacefulbabies
2025-04-03 15:08:34
This wrench was fairly expensive but I thought it would be one size fits all and a sturdy tool so I purchased it. Neither side of the tool works well. The beer faucet side is slightly too small due to the plastic guard which makes it difficult to fit on the nozzle for removal. The Hex Nut side is entirely too small and will not fit the nut on my kegerator. Be careful as there is no option for return or refund if you order this.
J McB
2025-02-28 12:10:12
Feels like a quality wrench for its purpose. This is a must have for a kegorator. The faucet spanner works great and the hex wrench side allows me to tighten down the beer line. Remember that all kegroator setups are different. Some people complain the the wrench side does not fit anything in their setup. In my case I have a home made keezer built from an older chest freezer for my homebrew. The 1 inch hex wrench fits on one of the three different sized nuts inside. Even if you cant use the hex wrench side the faucet spanner alone is worth the purchase.
Swooded
2025-02-13 14:18:19
Does the job, but the hook could be a bit larger. It slips out of the notch on one of my Perlick faucets pretty easily if I'm not applying pressure to keep it hooked (so holding it on the one end, while applying pressure to turn it on the other) and has left some light scuff lines. All in all, a much better option than scratching the whole piece with a wrench or pliers though
Werbs
2025-01-23 15:52:28
Haven't used it yet but looks and feels solid - a simple tool that I'm fairly certain will work just fine.
Uhgg
2024-12-14 19:49:36
There seems to but 2 models.I didn't receive the one pictured but it is the same model number.One doesn't have plastic on the handle as long as the other and there is a difference in the thickness of the handle.I received what I am guessing is a newer model with longer plastic to help prevent marring.The wrench end is for a particular type of nut on the back of an extension tube not for tightening the tap in.Whether this wrench works is dependent on yhe tap you own.It does the job on one tap but not a great fit on my other but works okishThey are different brand taps.Overall I would rate it soso 3/5
jeepe
2024-12-08 12:58:12
This was a backup unit for one I received in a kit. I wasn't sure of the quality of the one I was going to receive so I bought this as an extra. It is heavy and good quality. Works great!
Recommended Products
