Your cart is empty.
Your cart is empty.Product Description
10pcs 0-24V MOSFET Button IRF520 MOS Driver Module for Arduino MCU ARM Raspberry pi
The product instructions: PWM signal for high level effectively When the PWM for high level (3.3 V to 3.3 V) : As the power supply voltage, between V + and V - working indicator, work load When the PWM is low level (0 V to 0.5 V) : V + and V - between 0, work lights out, don't work load
dubya
September 3, 2025
Works as expected. Hooked it up as described on many web sites, and used example code for controlling a PWM motor... where my other MOSFET wouldn’t respond to 3.3 volts, this one did beautifully.
Xander Mirzadeh
August 4, 2025
So I wanted a simpler way to incorporate a MOSFET into my model rockets launchpad. Used one for solenoids and other for ignition. Simple to use and work every time.
Neil W. Harman
June 27, 2025
The MOSFET is installed to cloese to the board and there is not enough room to install a standard heatsink to it. The clearance between the back of the component and the V+ and V- block is not enough to let the heat sink fit, and the mosfet is to close to the board to attach a heatsink anyway.
Scott Pawelka
May 1, 2025
Will be used for a LED Mars light project
Neal D.
March 12, 2025
The units work very well with an Arduino or RPi source, and PWM signals work as expected. Unfortunately, they don't provide a schematic or wiring diagram, so it took me a bit of time to figure out how the thing works. Otherwise, it's great for the money.
William Assad
February 9, 2025
Product is awesome. It’s being used for my 12Volt RGB LED so that I can connect then to my 3-D printer and be able to monitor Temperature by just looking at the color of the enclosure. Blue for cold, red for hot, green for done, and white while in operation.
Kindle Customer
December 18, 2024
I used these to power 6V motors off of a 9V battery controlled by an Arduino Uno Rev3. This worked excellently. The Arduino used 5V logic and pulse width modulation controlled the motors speeds.Using a raspberry pi 4 with 3.3V logic these drivers were useless. Even using the full high 3.3V signal the driver would only let out enough current to dimly light an LED. It failed completely to turn on the 6V motors.
Svetlana
November 27, 2024
Out of 5 units only 4 work from 5v signal, one unit was shorted.1 star because of customer misinformation, these transistors work only with 5v, in the description it’s said to work with 3.3v which is false. Day of work wasted!Guys, check your product’s data sheet - this module uses IRF520 mosfet, it doesn’t activate until 4.5v applied according to it’s own data sheet.
Recommended Products
$24.90
$ 12 .99 $12.99