Your cart is empty.
Your cart is empty.Product Description
Using For
- Great for kitchen and flooring tables, outdoor frames, bedroom shelves, walls and more. create beautifully handmade furniture on your own.
Rall Bearing
- Having guide bearings can be reduced burn marks.
Grain carbide blade
- Industrial grade C3 micro grain carbide blade, more sharp, smooth cutting, impact resistance, high toughness.
Router Collett
- 1/2" to 1/4" Router Collett that easily fits into any router tables or router tools.
telpher mangrum
2025-09-06 12:18:33
Blew the bearing off the end first time I used it. My bad, I had the speed to high, replaced it with a new one and used correct speed, guess what, it preformed exactly as it was supposed to. Have used it several times now and it has worked very well and still sharp. Gladly recommend.
Racer441X
2025-08-28 15:29:42
I used it to round corners of counter top blanks.
drunkennewfiemidget
2025-08-27 15:35:16
I bought this with the intention of routing a soft corner on my butcher block countertop.I suppose I should've tried it in free air before going anywhere near the countertop.This thing was so horribly and comically out of balance that the router was basically aggressively throwing it everywhere, so it ended up bouncing off the wood, bending horribly, and then jamming.Nevermind how crazy unsafe that can be.I bought two expecting to wear this out and need another.The other one was the exact same way.Put one of my brand name bits back in the router and it's smooth as butter.In short: this is cheap, worthless, poorly made garbage.I'm now faced with the decision to either buy a whole new countertop, or deal with a massive gouge in this brand new one.Don't make the same mistake I did.
Mark M.
2025-07-31 19:58:56
Bit seems to be out of balance or slightly bent. Lower speeds produce pretty severe vibration under no-load conditions. Was sharp and cut well otherwise.
Hawkeye
2025-07-29 14:07:23
It was exactly what I was looking for - great tool ðŸ‘
Chet
2025-07-18 16:37:12
I liked the speedy delivery, the size and availability of it for my needs was nice, the price fit my budget was perfect, but the finish cut from this bit is the cherry on top. I’m using this bit for flush trimming a couple edges on decorative art wood mosaics, and it delivers exactly what I wanted!
WILLIAM D JOHNSON
2025-06-10 14:06:17
I needed this for a project where the double bearing was required.Did a great job. Stayed sharp!Works well.Good price and fast delivery!
Arrmon
2025-04-11 09:55:39
Bearing came apart on the tip after 20 minutes of use. I returned and ordered a new one as the project isn't done. The bearing has failed on several other people if you look at the reviews. The bearing is 12.7mm OD x 4.7mm ID x 4mm H if you want a replacement.Cutting edge and upper bearing were fine.
Mark Bornais
2025-02-09 13:50:43
Works well. Very good product.
Recommended Products