Your cart is empty.
Your cart is empty.Product Description
ZHSYMX Fuel Pressure Gauge 2‑1/16in 52mm Ultraslim 15PSI Red LED DC12V-24V with Alarm and Electronic Sensor for Car & Truck
Specification:
Item Type: Oil Pressure Gauge Kit
Material: ABS
Background Light: Red LED
Measuring Range: 0-15PSI
Working Voltage: 12V-24V
Applicable Models: General-purpose Car Modification
Fixed Size: 2-1/16in (52mm)
Sensor Mounting Thread: NPT 1/8in
Package List:
1 x Oil Pressure Gauge
1 x Pressure Sensor
1 x Power Wiring Harness
1 x User Manual
1 x Meter stand
Santanna Mosbrucker
April 29, 2025
Ordered this for my car parts do not fit together. It quite working after a week. Ordered a replacement same problem.
House of Jensens
April 26, 2025
I have this on my 89 F250 7.3l diesel. It requires ~5psi input pressure and this gauge keeps me informed!It comes with everything needed for install, using a 1/8" NPT electronic sender. The wire that goes through the firewall between gauge and sender isn't super thick and the plug is small enough to jam through most grommets.I really like the way it displays, the red is easy to read but not blinding. Unfortunately it doesn't dim, I tried that, but again isn't too bad at night.I use waste motor oil at times for fuel, which is much thicker, and I've been having fuel supply issues from it. This gauge is VERY nice to have because of those issues, and help me to see exactly when I start to have a loss of pressure. It's helped me to narrow down which tank is having a problem. I haven't finished troubleshooting it, but I installed this gauge for this issue and for the future as my fuel supply system can't always keep up with my now turbo diesel's needs at wide open throttle.I also like that it shows 0psi, but also shows - - - - when there is a vacuum. That's a big deal if you're drawing a vacuum, ends up happening on these old diesels so it's great to know exactly when that happens, so you don't get caught between tanks and stall on a hill or something.The only real issue I had was that the bezel isn't the right size for the gauge. It's not even close, either, as I had to use a ring of thin carboard around the whole circumference of the gauge to make it have a firm fit inside the bezel. BUT, a little hot glue and carboard and this thing isn't going anywhere.
Nick
December 31, 2024
Pictures.1. With fuel pump running it's reading blank.2. Resetting the warning value I can't go below 15 psi (sensor is 15psi and gauge is suppose to be 0-15psi)3. Warning value is 15-55psi. I'm also really hoping that warning is set for below a value as it's fuel so I only need to know if the psi drops below a value.Will update if I get working or get a response from the company.Edit. Nice the seller messaged me back right away. So far we've wasted 3 messages implying I've wired it incorrectly. The sensor cannot be wired wrong and the only other wires are red and black
Recommended Products