Your cart is empty.
Your cart is empty.Product Description
COPPER BRAZING RODS
Model Number: BCUP-2
Material: Copper / Copper Alloy
Packag： Sealed tube packaging
Size：400mm*1.26mm*2.83mm
Weight ：0.26lb/10 Rods
Advantage: Excellent ductility, Smooth incision
Welding Type: Flame welding/ Brazing
Copper Brazing Rods
Phos-copper Brazing Alloy
Phos-copper brazing alloy(No silver solder) is base on the raw material with the binary alloy of copper-phosphorus.It has good fluidity,good strength, low cost, perfect processing property.
No need to add flux when brazing copper and silver.It’s suitable for brazing copper with copper alloy in air-conditioners, refrigerators, evaporator, heat exchanger, water heater, etc.
- WELDING MATERIAL：Copper to copper alloy, Copper to stainless steel , Copper to brass，Copper to aluminium，Repairing alumi nium welding
- APPLICATION : Brazing, Refrigerating system / Heating system
Harleyman
July 17, 2025
These work very good for HVAC Work.
Patrick
June 23, 2025
They serve their purpose perfectly
Badanasinghe n c fernando
May 21, 2025
Â
Frank Varano
May 2, 2025
These don’t work. I tried 2 sticks and they require excessive heat to the point of where the base metal was damaged. Get the Hobart brand brazing rods. They actually work.
Fred Hood
April 22, 2025
Went on smoothly
Jeremy J Horton
February 27, 2025
Tried multiple times on aluminum stock. Watched about 20 YouTube videos and gave it a shot with mapp gas torch without any luck. I gave 3 stars because maybe it works with oxy torches? I had the metal at aluminum at 750-800 degrees and nothing.
bikeman16
February 26, 2025
Worked as intended
Daniel C.
January 8, 2025
Package contains 10 sticks, total weight is 4oz, no specs or marking except raised letters on the sticks saying CHINA and OIXING. I was intrigued if a regular handheld propane torch/tank could achieve enough heat to braze copper with these. I found a 4†stub of 1/2†Type L copper with a brass ferrule from a compression fitting on it, seemed like a perfect candidate. The torch had no problem heating the ferrule, in fact it could get it red hot easily. Heating the copper tubing was much slower, but after a minute it got hot enough for the brazing rod to start to flow. As I said this is a stub of copper held at one end in a vise, so it was pretty well isolated. I think it would be a struggle to heat tube that was located near a large fitting, but you could do small hobby and craft stuff with a propane torch. Then I switched over to a TIG torch, set to 100a max. With this it was easy to heat the copper tube and the brazing rod flowed well.
Recommended Products