Your cart is empty.
Your cart is empty.Note: When replacing the paddles, you need to use the paddles in the same package, do not mix with the blades in other packaging, it is recommended that you purchase two pairs at the same time for replacement.
LMcD
2025-08-10 13:41:21
Packed easy to understand
Private Eye
2025-08-03 13:46:41
Very happy, fast shipping
Gustavo
2025-07-22 12:03:21
Es lo que promete
James & Kathleen Cogan
2025-06-04 14:43:25
The quality is distinguishable from DJI props.
Jo C
2025-04-08 10:27:32
Screws are a little weird. They’re kind of mushroom-headed v.s. the original flat-head screws you see with DJI. Doesn’t affect anything at all, just an observation. Anyway, these are the ones you want. They have that material on the tip that just makes the drone fly so smooth. Cheap and good.
Angel Alejandro
2025-04-01 11:10:48
Great product for replacing damaged blades
Hayden
2025-03-20 18:24:06
These blades are .40g heavier than they should be. Therefore, if you replace one blade, you MUST replace them all or the drone will be off balance. I would recommend not purchasing this product for this reason.
Javier Rodriguez
2025-02-16 13:35:46
So the propelers look ok , however they dont come maked A or B you just have to compare with the ones you take off and hope for the best.
Klaus
2025-01-09 14:29:56
These dji mini 3/4 propellers are very nice and very flexible and look exactly like the original ones and the orange tips seem like they are tpu material as when you tap on the orange tip and the black area right beside the sound is very different like the orange rip is a much more quiet tap...and I know there was a review out there saying but from another seller but same looking item..that there no marks to tell which blades went to with motor and this is not correct as even it shows in the description photo that there is and the Pic I have of the two opposite blades and if you look at the right two blades near were the screw holes are you will seen a curved line is actually sticks up on the blade abit and the two blades on the left have no curve line on them at all in that same location and this is how you tell the difference between the two...so putting them on the drone should be pretty easy...just look at the blade on the drone and see which motors take which one and they will go in pairs either with no mark or a mark and they go crisscross from each other these blades like front left front and rear right and right front and rear left as you are looking at the back of the drone..just check each pair of blades on each motor to see if a mark or not is on them and just install the same blade with the new one were you removed the old one from..and they include many screws also which is nice...happy flying to you all. 😊
Recommended Products
