Your cart is empty.
Your cart is empty.QuickClip Pro
These are what got us started, hard to find open back-slotted posts. We had a military contractor looking for a heavy duty 1/8” Binding Post Hardware for some bags & holster attachments. We searched everywhere to find these but couldn’t and resorted to having the tooling made for us in the USA.
These are not your average Chicago binding posts and screws, these are made to exceed Mil-Spec standards, even our Black Oxide Finish is an Ultra Deep Black that will outlast any other brand.
They are mostly used for mounting knife sheath and gun holster attachments, fixing & fastening leather straps, sandal buttons, boots, belts knives, use in place of fastener rivets. Because they are slotted, they can be easily tightened or removed. These use an industry standard #8-32 thread. Screwpost Packs in quantities of 10 or 25 piece match sets.
SPECIFICATIONS:
✔ Standard Head Screw - 0.375" Head Diameter, Overall Length 0.215”, 0.125” Length Under Head
✔ Flat Head Screws - 0.410" Head Diameter, Overall Length 0.225”, 0.125” Length Under Head
✔ Binding Posts - 0.420" Head Diameter, Overall Length 0.195”, 0.125” Length Under Head
✔ #8-32 Threaded, 0.20” Barrel Diameter
✔ 10 Pack or 25 Pack (10 Each of Phillips Screws & 10 Each Binding Post)
✔ Ultra Deep Black Oxide Coating, with dry finish lubricant
✔ Min Clamp dimensions – 0.125” Max 0.175”
✔ Mil-Spec Approved: (MIL-DTL-13924)
✔ Lifetime No-B.S. No Hassle Warranty
✔ 100% Made in America !
Buy the best once, QuickClip-Pro!
Ranger
2025-07-28 18:18:19
I needed something with an extremely low profile to anchor the looped ends of some 1/16th diameter tensioning cables for my replacement convertible top on a car. The factory original anchors were some very trick large head rivets that I had to drill out, and the fabric lays down over the rivet locations, so the replacement anchor solution needed to be almost flush or it would create a noticeable lump. The inside also needed to be low profile, not as critical, but as it is visible I didn't want just an ugly pop rivet sticking through. These 1/8" were perfect - the steel bow of the convertible top frame is about 16 gauge and the cable, when flattened by the Chicago screw was 3/64ths, so about 1/16th total and that let the Chicago screw thread up nicely while being nearly perfectly flat from and back. The black finish made them blend in nicely, and I expect they are plenty strong for the job I'm asking them to do.
Rocky
2025-07-08 18:38:56
No issues with this product
tommmy alexander
2025-06-22 10:50:24
Replaced older silver screws for shorter black one made my shoulder holster look much better
Bryan
2025-06-13 09:29:21
Like a champ
W. Eng
2025-04-22 18:54:13
It was exactly as described.
James M. Ogle
2025-03-29 11:27:55
Not bad quality. Finish could be better but works as expected
OsoSoDude
2025-02-17 15:29:44
Very high quality, but I needed screw to be a little longer. Tightened my holster for my pistol very well.
Roman Holland
2025-01-23 16:19:26
I had been looking for one of these all over and I ordered this from Amazon and it was exactly what I needed to fix my mailbox.
Recommended Products
