Your cart is empty.
Your cart is empty.Product Description
ShotintheDark
2025-09-02 17:38:03
If you are using these for a can ...Suppressor and are concerned about proper concentricity ..Do NOT I am a machinist and bought these due to price ...cheaper to buy than to make them..I Put them on a mandrel in my chuck and they have less than .003" total run out ...I faced them off at the rear and had zero...Be sure to remove the O ring ...seat the flange against the shoulder of your barrel thread.Install a bit of rocksett ....
Jamiedmelcher
2025-08-12 15:04:50
A
James W. Brown
2025-08-10 17:49:19
Bought these for attaching a suppressor to my rifles. These are much better than one’s Silencer Central sells at 1/4 the price
-rsh
2025-04-08 09:52:55
These are aluminum and NOT stainless steel as advertised.
CB
2025-02-22 11:42:09
Not as described as being black. It is stainless in color.
Charles C.
2025-01-28 19:27:06
Ordered to correct my mistake on the thread of a nodular muffler for a shop compressor. Can’t be outside and super loud Close but not right.
Twila Zay
2025-01-15 15:17:29
Works good pleased
Recommended Products