Your cart is empty.
Your cart is empty.Product Description
KWIKBIT
2025-08-22 09:17:20
I'm using them to keep the snow and ice off of my satelite dish! I got tired of having to brush it off every time it snowed! Individually they get too hot so I wired the 2 in series with a thermostatic control set to 40 degrees. Attached one on each lower side of the mount and problem solved for under $50! I didn't trust the self adhesive so I applied weatherproof epoxy around the edges.
Abrams
2025-08-16 17:39:52
Hope these work. If they do it was a great investment and way to install
Kendall
2025-06-03 19:52:01
I wish I had a picture of it, but this tiny heating pad works perfect for my Canam Outlander 400. It has a problem starting in the winter and now I plug it in and within seconds it starts heating up the oil. Super great price and DURABLE cord. They don't cheap out with the plugin cord. It's thick.
Shawn Storm
2025-05-30 10:47:54
Cleaned my oil pan and waited hours to ensure it was dry. The mat stuck for less than an hour. I had to get some heat-resistant liquid weld. A warmer is essential in my state to have a functioning vehicle through the winter.The pad warms quickly, and I believe it will do a great job. The only other advice I would give the seller, other than to improve its adhesive, is to include materials to a fix the cord so it does not hang down.
Lads
2025-05-27 14:01:07
Work great for low price.
Cheechako J
2025-05-15 18:28:52
This worked for less than a year, one winter season at best. I put it on a Gator sidexside at the expense of getting on the floor under the engine and lowering the skid plate to access the oil pan. Not a 30 minute job! Too much work for me to bother with replacing it. I really don't know when it stopped working. I discovered it was dead last December when it was single digit cold every morning. I use the Gator daily to get around my place, so depend on it starting. I would not use this type of heater again on an engine so hard to get at. The old magnetic Kat's 110volt heaters never failed me. But I worry about them falling off and I'd never know it since the skid plate would hold it from view. So in closing I'd suggest never to use this heater where you can't touch it to test its effectiveness. It may only last one day!
7
2025-03-28 12:00:15
adhesive holds up and cable quality is nice, gets hot.
James Swann
2025-03-07 14:17:06
Every vehicle I own for the last several years I always put one of these heating pads on the oil pan . Even brand new cars that I buy it definitely helps the motor last a lot longer and less wear and tear during cold start ups . I bought a 2012 Ford fusion brand new put one of these on the first week that I had it plugged it in every night through fall winter and spring . Still in the car and it currently has 287,524 miles on it and still runs great . Between using this heating pad and always using premium oil Mobile one full synthetic and a premium oil filter . The only thing that ever failed on this car was the driver side heated seat other than that the car has never been in the shop for anything other than wearable items like brake pads . Also my 1996 Toyota Celica ST same thing bought it brand new heating pad on the oil pan and premium oil again never has been in the shop for anything other than wearable items do yourself a favor and every vehicle you have put one of these heating pads on the oil pan . Cold start ups are the worst thing for a vehicle
Brian Oldridge
2025-02-24 18:12:06
Was advertised. Installed on a water dish. Works great. Heat was perfect for the 2 liter capacity even at -30. Not too hot and temperature controlled.
richard p.
2025-01-23 14:29:03
attention ne colle pas sur de l’acier, utiliser du silicone haute chaleur
Jonathan g.
2024-11-13 14:53:48
Ne colle pas.
Recommended Products