Your cart is empty.
Your cart is empty.Product Description
ETL Performance 2007-2018 Wrangler JK Exhaust Kit Axle-Back Exhaust Kit Wrangler JK Muffler Exhaust system Wrangler JK accessories
ETL Performance 2007 2008 2009 2010 2011 2012 2013 2014 2015 2016 2017 2018 Wrangler JK axle-back Exhaust Kit. This kit comes with all components needed for installation including exhaust muffler and piping, exhaust clamps, and 2 muffler tips. Professional installation is recommended.
Stainless Construction
High-quality 409 Stainless Steel Muffler and Tubes, high-quality 304 Stainless Steel Muffler Tips and Clamp, providing a good corrosion resistance.
High Temperature Resistant Black Coating
High Temperature Resistant Black Coating provides a good durability.
ETL High Performance Wrangler JK Exhaust Kit
ETL Pertormance 2007-2018 Wrangler JK exhaust is designed to enhance low and mid range performance for climbing and towing. This High Tempreture Resistant Black Coated Dual Exhaust exits provide plenty of ground clearance both On Road and Off Road. Offered with Dual Large diameter Rolled Edge Black Coated Exhaust tips, a Hassle free, bolt-on installation with professional results.
gary pion
2025-08-09 09:55:04
Easy to install looks and sounds awsome
M. Frady
2025-07-19 10:35:39
This is a direct bolt on to a factory 2016JK. It sounds great but to get the most sound out of it, I put on a cold air intake that really opened up the sound quality. (RiAiCiING Cold Air Intake kit with Heat Shield Fit for 2012-2018 Jeep Wrangler JK 3.6L V6).I sprayed PB blaster on the factory exhaust bolt and around the exhaust connection and let it sit for about 30 minutes. I also sprayed WD40 in the exhaust hangers to loosen them up. The hardest part was getting the passenger side hanger disconnected so I ended up just cutting the bracket off the factory exhaust. Once both hangers were loosed and the bolt loosened from the exhaust connection, it was just a matter of wiggling the muffler left and right and few light taps with a rubber mallet to brake it free. The new exhaust bolted right up and fit great. The major problem I had was putting the tips on. The bracket where the bolt and nut are does not allow enough room to get a socket on it so I had to use an opened wrench and with tiny micro turns I was able to get them tightened on.
Joseph Brooks
2025-07-18 15:13:27
Getting the factory exhaust was the “ hardest “ part of this installation. I used some sandpaper to clean up the old exhaust to help slip the new one over. It went on without any trouble. Getting the hangers back it was a little fight but that didn’t take too long either. I a little bit of grease and that helped a lot. I didn’t put the tips on. I didn’t like the way it looked. Too big from the exhaust pipe but that’ll be your choice. I had a really annoying rattle once I started it up and found out the heat shield was vibrating really bad. I ended up just taking it off. The new exhaust is much smaller then the factory and didn’t sit anywhere close to the body of the Jeep. Sounds great for the price! Well worth the money and didn’t take much tome at all!
Ryan T
2025-07-11 14:39:05
The system arrived and it was made of good quality, no issues. The install was easy and matched up to the hangers and existing pipe.The sounds is aggressive at start up and acceleration until you get to the cruising speeds and then you don’t hear it as much, which is what I was looking for. I have a soft top so I didn’t want a super aggressive tone as I am driving for a long period of time at cruising speeds. I can’t complain about anything at this point, if anything changes I will update. Great but for a decent price.
J4orick
2025-06-23 13:29:34
This is significantly louder than my previously installed ( same design ) muffler. Not worth the labor cost to return it and incur a second install charge on a different muffler so just beware as my Jeep sounds like a diesel
Customer
2025-05-29 12:34:33
The media could not be loaded.
terryfoster2u
2025-05-27 13:18:55
Right out of the box, its looks very well built, but time will tell how long it will last. It was a snap to install onto the existing Jeep rubber hangers on my 2013 Wrangler; the hanging and clamping to only about 30 minutes. I would highly suggest cleaning the Jeep tailpipe with an abrasive like 100 grit sandpaper or equivalent as to make the transition slide on easier. The muffler exhaust extensions are slash cut and heavy; better than I expected. I would liked a better sound, the sound I get when revved is like that of a teenager's Honda Civic. At idle, it sounds throaty, but when at highway speeds, you have a droning sound, but what can you expect when you don't have headers. Why pay 500 bucks for any other item, when this one is the best bang for your buck? Time will only tell how long it will last, but it is heavy steel and well built, so I believe it will outlast the Catback and the Dynomax.
Shannon
2025-05-16 14:55:54
The media could not be loaded.
Ahmad hamouda
2025-04-19 15:06:38
I installed it on my 2012 JK8 , it gives very good sound and it looks perfect. Cheap & good . I love it
Raymundo Jimenez
2025-03-03 15:28:58
Luce muy bien y el sonido es Agaradable hace lo que tiene que hacer lucir bien y escucharce bien
Customer
2025-01-14 14:09:19
Tucks up nicely... love the black and sounds mean, but not overly loud. 2018 2dr jeep jk. Get rid if that stock beast muffler
k munro
2025-01-03 19:48:26
As described hidden fees if coming into Canada can by similar here for a wee bit cheaper but decent exhaust for the money
Jesse Mackie
2024-12-20 12:36:01
Sounds great! Install wasn't the smoothest, old exhaust was a little challenging to pop off. The clamp that came with it was too big. Sounds and looks good all troubles aside.
Recommended Products