Your cart is empty.
Your cart is empty.22-20 Ga. Female Metri-Pack Terminals, GT 150 Series, Sealed #12191818 Metri-Pack terminals are different from Weather-Pack terminals in that the male terminals have flat pins, similar to a quick disconnect, rather than Weather-Pack's round pins._x000D_ _x000D_ Easily determine the Metri-Pack series by measuring the width of the flat pin. Metri-Pack 150 series = 1.5 mm pin width. Metri-Pack 280 = 2.8 mm pin width. Metri-Pack 480 = 4.8 mm pin width. Metri-Pack 630 = 6.3 mm pin width._x000D_ _x000D_ These sealed terminals require a seal for each terminal and sealed housings._x000D_ _x000D_ Terminals require two crimps (terminal to wire strands, terminal to seal to wire insulation). A proper crimping tool is required. For heavier usage, use a tool that performs both crimps at the same time.
Cheap skate
August 26, 2025
Genuine terminal. Buy many as too many ways to mess these up
Tino kalantzis
August 17, 2025
Well.. Long story short ... one of the wires that goes to the pedal height adjustment switch got ripped out of the connector when I took my dash board off to replace the ac condenser that was leaking. I looked everywhere and could not find the name of the connector or nothing ... this is the same exact thing the factory uses. Im glad I found these.
joe
August 4, 2025
Did the job
Andy Blume
June 27, 2025
Just what I needed for my repair
J. W.
April 27, 2025
Worked perfect to replace a broken pin on my AEM flex fuel sensor. The connector was a 4 pin GT 150 seal connector. Only difference I could see what the metal was not as shiny as those provided by AEM
JT
March 22, 2025
These connectors just absolutely suck. They're NOT Metri-Pac and are certainly not pull-to-seat, not having a prong to seat them in the terminal (instead they have a chintzy, cheap, useless dangling appendage of a tang that doesn't hold the connector remotely in position). And the cheaply-coated metal snaps more often at the secondary crimp rather than at the end of the connector. Trying to seat these also resulted in a connector snapping in half.STAY! AWAY!
Angel llano zapata
January 12, 2025
I use for Aem wiring ecu
greg heller
November 21, 2024
This product worked very well.
Recommended Products
