Your cart is empty.
Your cart is empty.Bill
July 15, 2025
These are just what I was after. I had a few pieces of similar design pulled from old equipment. I needed a size I did not have and there were several in the box to meet the need. The range of values is very good for this design. They go easily onto PC boards.
Ogi
July 10, 2025
Good selection and accurate value. The 100mH measured 100.6mH, Q was 2.021. 470 uH tested 465.1uH. The 670uH tested 671.2uH, Q=1.241. The individual inductors are not marked, so if you spill them from the box ... you will have a lot of fun.
A geek
July 3, 2025
It is an assortment of inductors. They are not marked as far as I can see. That's a problem if you don't have an LCR meter, and I don't. I can roughly test using my scope and a tank circuit and also a TC1 tester. I am not sure that all of the values are as specified. For example, the 470uH and 680uH parts test very similarly for me-- at a value intermediate between 470 and 680. Other values are not all similar, so this is an assortment of various inductors, e.g. the 100mH parts appear to be in the neighborhood of 100mH. But I am not not how many different values there really are.So, you will need to test these parts as best you can before using them seriously.
Eric
July 1, 2025
Great buy for having a wide selection of inductor values! Would be wise to have an inductor tester, cause they are unlabeled but look the same!The tolerance or resistance wasn't specified, but for the record, measuring the ten 100 mH ones I got a mean of 98.39 mH with standard deviation of 1.17 mH (range of 96.57 mH to 100 mH). They had a mean resistance of 303.16 ohms with standard deviation 4.32 ohms (range 296.2 ohms to 308.5 ohms).Also I measured a 10 mH one and it had resistance around 28.4 ohms, a 1 mH had resistance of 4.4 ohm, a 100 uH had .7 ohms, 10 uH had .43 ohms, 2.2 uH had .14 ohms.
Nobbler
June 24, 2025
Most of the inductors are not labeled (95%)
Customer
June 17, 2025
A fun game for the whole family.
Algernon
March 9, 2025
Not a kit that should be purchased if you do not own an LCR meter or one of those little do-it-all component testers. Values are reasonably close so far in ones I have sampled, but I do not expect too much since inductance is frequency dependent. They do come in a nice segmented case!
Customer
February 17, 2025
I got this to give me some flexibility in selecting small inductors for various electronics projects - it is a nice assortment. I tested these on a meter and they came out very close to rated values.
Recommended Products