Your cart is empty.
Your cart is empty.Product Description
2 claw puller-Anti-falling off design
2 claw puller：With anti-falling off design on the beam, it is not easy to fall off when using, and it is convenient and saves trouble.
10" 2 gear puller-Sleek end
10" 2 gear puller：The design of the ball top is not easy to hurt the bearing workpiece.
2 jaw puller-Top hexagon
2 jaw puller：Top hexagon design is more suitable for the additional force tool.
gear puller 2 jaw at the time of purchase, please check the size
Hartland Guy
2025-08-08 17:00:02
Good build quality
John
2025-07-31 16:17:25
Fast shipping, works great. Great price, Would buy again.
Tom Nishimura
2025-07-05 16:49:29
It's designed well, easy to handle.
Kindle Customer
2025-05-27 15:59:46
Worked great, need to remove a drum brake from a medium duty truck and did the job, Held up , good pric for the money
Velvet Rob
2025-05-05 13:58:27
I have a 1968 Ford Mustang and was unable to rotate its rear left wheel. The brakes were unresponsive, and the drum was fused on. I tried hammering it and hitting it the best I could from the back. The drum did not have the option to remove it by using a bolt.This tool ended up being a little too small, but I was able to place the claws at a point just before they would fall off their support and it was able to pry the drum off along with me hitting the drum with a hammer.I'm so grateful to have found this tool, I wasted way too much time and frustration without it.
Sheldon
2025-04-18 11:48:28
UpdatePulled another fan hub. Very few problems despite hub fighting me entire time.Getting heavy where on hex head of jack shaft. Won't be long until unusable. Use of impact wrench is discouraged./updateCheap.Flimsy.Difficult to use.Other than that, I did get that @#$% fan hub pulled off.
John Isbell
2025-04-02 13:39:00
I bought this to pull a stuck multi-groove pulley off the motor shaf of my drill press. When I assembled the puller I thought the fit of the threaded screw in the puller body was sloppy and would strip out under pressure bu I was wrong. Even using an extension on the socket wrench I was using didn't strip it. The pulley finally broke instead. This is a good tool even though it is made in China.
Tim
2025-02-19 18:27:12
Pulled off the pulley/bearing and the coil separately from my A/C compressor. Bearing/pulley are very difficult to remove if rusted (mine was) and coil is pressed on. This puller allowed me to remove these parts without removing compressor from the engine ( 02 F150 V8 ). Puller rated at 2.5 tons of pull. I didn't need anywhere near that power. May try using puller to press on replacement parts. Yes I took a break after removing parts. I'm 72 and it's hot now (August ) heat index of 102 right now.
Recommended Products