Shopping Cart

Your cart is empty.

Your cart is empty.

2-Pack, (3-Way) Conductors.Pin, 30 Amp Metri-Pack Waterproof Connector Terminals and Seals Wire Gauge Size 12-10 GA

Free shipping on orders over $29.99

$16.99

$ 7 .99 $7.99

In Stock

1.Size:1-pin


About this item

  • 2-PACK (3-PIN) Metri-Pack 280 Series Sealed System ( 16V up to 30 Amps )
  • Gauge Wire: 12 10 AWG
  • Using OEM (connector, lock, seals, and terminals)
  • Professional installation recommended
  • Temperature Rating: -60F (-51C) to 257F (125C)



Furyem
September 2, 2025
.
J. M. Becker
August 15, 2025
Good for "higher current" wiring. Good Quality but I recommend a good crimping tool to make the best connections to wires for strength and firm connections.
rederikus
August 14, 2025
These conectors are well made and easy enough to assemble. I chaose to solder the conductors to the metal connector pins. I am using 10 Gauge double insulated cable for outdoor burial The conductor fots perfectly but the red and black insulation will not permit the blue silicone cable selas to enter the connector body. I ended up using silicone caulking to waterproof the connector at the cable entry ends.I believe that these conectors are suitable only to 12 Gauge insulated cable.
Alicia Calkins
August 13, 2025
There are no directions for putting these together, so you have to figure it out yourself. Being that I have put some of these together in the past was not hard to figure out that the female terminal went into the shorter plastic housing and the male terminal when in the longer plastic housing. Other than that, went together and connected together easy. I used Di-electric grease to make assembly easier and add another layer of water proofing.
Corey R.
July 23, 2025
Quality is good but getting 10 awg wire to work is challenging to say the least.
Brian
June 28, 2025
Nice quality. Used to add FI to my car and these seemed sturdy and up to the task. Would use them again, recommend.
Dave Barbara
May 30, 2025
Easy to use. Not as weatherproof as I would have liked. Coated them with liquid electrical tape
Mike C.
May 17, 2025
These 30Amp Metri-Pack Waterproof Connector Terminals work well on repairing older broken connectors or for adding in a connection point for a new component. You will need to have a special crimper to do a single crimp for both the wire and the seal, but it could be done separately with some ingenuity. Overall, these work as advertised.
Furyem
April 30, 2025
.
J. M. Becker
April 25, 2025
Good for "higher current" wiring. Good Quality but I recommend a good crimping tool to make the best connections to wires for strength and firm connections.
rederikus
April 2, 2025
These conectors are well made and easy enough to assemble. I chaose to solder the conductors to the metal connector pins. I am using 10 Gauge double insulated cable for outdoor burial The conductor fots perfectly but the red and black insulation will not permit the blue silicone cable selas to enter the connector body. I ended up using silicone caulking to waterproof the connector at the cable entry ends.I believe that these conectors are suitable only to 12 Gauge insulated cable.
Alicia Calkins
January 24, 2025
There are no directions for putting these together, so you have to figure it out yourself. Being that I have put some of these together in the past was not hard to figure out that the female terminal went into the shorter plastic housing and the male terminal when in the longer plastic housing. Other than that, went together and connected together easy. I used Di-electric grease to make assembly easier and add another layer of water proofing.
Corey R.
December 5, 2024
Quality is good but getting 10 awg wire to work is challenging to say the least.
Brian
November 26, 2024
Nice quality. Used to add FI to my car and these seemed sturdy and up to the task. Would use them again, recommend.
Dave Barbara
November 23, 2024
Easy to use. Not as weatherproof as I would have liked. Coated them with liquid electrical tape
Mike C.
November 12, 2024
These 30Amp Metri-Pack Waterproof Connector Terminals work well on repairing older broken connectors or for adding in a connection point for a new component. You will need to have a special crimper to do a single crimp for both the wire and the seal, but it could be done separately with some ingenuity. Overall, these work as advertised.