Your cart is empty.
Your cart is empty.
30 series complete driver clutch with 3/4" ID hole,Widely used on go karts, bikes, lawn mowers and any more with 3/4" shaft.
Specifications:
1. Material: Iron
2. Replace: For Manco 5957, For 203814 / 219552 / 219457, For Yerf Dog Q43201W
3. Centrifugal Clutch: 3/4" Bore
4. Drive clutch bore:3/4 inches (19.05mm)
5. Key way:3/16"
6. Belt: Asymmetrical belt
7. Recommended engine:2HP-8HP
8. Fits engines with 3/4" shaft
9. 30 Series Torque Converter Driver Clutch, 6" diameter with 3/4" Bore
10. Uses a 3/4" Asymetrical Belt (Not Included)
11. Easy to install
Attention:1) Torque converter drive pulley must be bolted tightly to the engine crankshaft. Recommended engine power 3hp to 8hp.
2) 2 1/2° angle (flat side) of belt must be against the 2 1/2° angle pulley flange(Next to engine).
Cleanup
2025-08-24 13:14:05
Go-kart went on easy
Jamie mckinnon
2025-06-25 10:03:29
The best 30 bucks I’ve ever spent works great nothings wrong with it
Cameron Coffey
2025-02-24 11:40:56
The driver did not fit the crankshaft, the inside is not milled out correctly and the driver won't slide on. Be warned.
Customer
2025-02-18 17:47:28
This converter was used to drive a simple v-belt for an engine swap on a 1952 Planet Jr. garden tractor. I don't know how long the v-belt will last as it is not really the correct belt for a torque converter. The driven pulley does fit the v-belt. This will engage at low rpm.
Recommended Products
