Your cart is empty.
Your cart is empty. Packing list:
1 * T8x2 365mm lead screw
1 * T8x2 brass nut(flange cutted)
The lead of the thread is 2mm, which means that the nut will move 2mm if the nut turns one circle.
The advantages of the lead screw are:
Large load carrying capability
Compact
Large mechanical advantage
Precise and accurate linear motion
Smooth, quiet, and low maintenance, very suitable for 3D printer z axis.
Minimal number of parts
So this lead screw is very suitable for 3D printer Z axis, such as Ultimaker and Prusa i3.
The screw type of this lead screw is ACME thread.
ACME Threads are generally stronger than square threads due to their trapezoidal thread profile, which provides greater load-bearing capabilities.
ejh
2025-01-24 18:39:03
They don't make the list of compatible printers very clear. I ended up ordering the wrong rod for my printer (2mm but needed 8mm). Luckily my printer's firmware supported adjusting the z steps enough that I could compensate by quadrupling the amount (400steps/mm to 1600steps/mm) but that wouldn't have been necessary had I known the correct ride to order. Seller, please update your list of supported printers.Otherwise? The rod is fine. Install was easy and I've had no other issues thus far.
Joshua Anders
2024-11-27 16:11:33
purchased for my ender 3 v2 neo to fix the z wobble and the droop when steppers are disabled and is the wrong pitch for the neo, so it times out when trying to home and freaks out the printer not seeing it activating the stop switch when it is supposed to, Im sure it would work perfectly if it was the right pitch but is NOT for the v2 neo
Recommended Products
