Your cart is empty.
Your cart is empty.
This item is used for third brake light. With the convenience of an easy peel off adhesive backing , the material can be put in place, then moved for slight adjustments, stays in place for installation. It's a pretty good choice to replace the old and dull part as an ideal solution for the water leak problem. Check Compatibility table before ordering.
Package includes:
1 gasket with 1 manual
Compatibility:
2005 to 2019 Frontier, 2004 to 2015 Titan
Specifics and Features:
Foam seal , Enough thick foam can provide excellent waterproof performance.
Made of high quality material,can be used for long time normally
Easy to install, perfect cutting edge makes the installation become simpler
Warranty and Customer Service:
1. 90 Day manufacturer warranty since order purchase date.
2. Feel free to send email first if there's any issue before or after purchase. All emails will be replied within 24 hours. Your case will be taken seriously regardless of warranty period.
Prestige Worldwide
July 25, 2025
The gasket fit the light housing for my 2011 Nissan Titan perfectly. It is definitely thicker than the OEM gasket, but I had no problem reinstalling the housing. The hardest part of the job was removing the old gasket from the housing so the new gasket could be mounted properly. No more leak!
Deadguy
July 18, 2025
This replacement gasket fixed the leak I had coming through the 3rd brake light assembly. Easy to install and worked great.
Paul
June 27, 2025
Excellent product. Resealed the 3rd brake housing on my 2014 Titan. Great repair
Jonas Chanh
June 26, 2025
Like everyone else did say, it doesn't run a bit thick. Hopefully it doesn’t make wind noise. I have not tested it out yet but I’ll update this on a later date after use.I unscrew the lights and cleaned the old gunk off to the best of what I can. I didn’t use rubbing alcohol, I just used a cleaning rag. Stuck the adhesive side to the light fixture and snug the 8mm bolt. Be sure not to over tighten bc this new gasket runs a bit thickIf the creator is reading, make this a little thinner would be great!
GARS
May 14, 2025
.
AArzola
May 13, 2025
This gasket is thicker and makes a better seal than the original.
Fair reviewer
March 31, 2025
Yes, this is a bit thick as others mentioned in their review. Take your time to scrape out the old seal, clean with alcohol, let it dry before applying the seal. I applied the sticky side onto the car directly, not the light housing. I made some small adjustment before applying full pressure (pressed hard on it thoroughly). Reinstall the light housing as instructed. The light housing does stick out and not flush as originally would. The instruction indicates silicone as optional but not necessary. So, I went with no silicone. Took the truck out to a car wash, no leakage. Now got to wait for mother nature to unleash a major storm to see how it hold up. I also replaced the light bulbs with three LED during this time. I think it is a better way to go (keeping the original light housing) if you want to upgrade to LED than to buy the whole new LED housing and risk connectors do not work.
Michael Dicken
December 31, 2024
Get what you pay for
Daniel
December 11, 2024
Perfect fit no more leaks
Recommended Products
