Your cart is empty.
Your cart is empty.Product Description
K3134 OEM / Interchange Numbers: 04746696, 4746696, 68004085AA, 83500202, 8983500202, K3134T, K7208, K7208T
K3185 OEM / Interchange Numbers: 5012432AA, 68004085AA
Pete
2025-07-31 13:35:42
Better design.lower ball was serrated. Worked as they should.
johnny Locklair
2025-06-16 13:43:29
A++++++
Dan R.
2025-06-11 09:38:39
I bought a ball joint press that worked great but it was still a job and a hard one. The new ball joints fit great,it was the old ones that were a problem to get out.
Sergio Cadiz
2025-05-30 17:43:50
Las partes son de buena calidad y funcionaron muy bien.
Thomas
2025-05-23 14:07:02
This product is too large to fit into the steering knuckle. I had to buy another set of ball joints. Don’t buy it if you have a Ranger 4x4 it doesn’t fit.
Anthony pham
2025-05-18 16:42:44
It fits but the grease cover is loose causing grease to leak out. The zerk fitting on the lower ball joint tears right off from axle spinning. I hope it last long
Josh Gunn
2025-05-02 13:26:00
Lowers fit fine, uppers are too short and will not allow the bushings be re-installed or the pinch bolt to go back in.
Billy Church
2025-04-24 17:57:07
Great balljoints ,just like factory original, not to bad to install with the right tools.
Pete
2025-04-10 09:05:37
Better design.lower ball was serrated. Worked as they should.
johnny Locklair
2025-03-02 14:51:45
A++++++
Dan R.
2025-02-27 13:32:46
I bought a ball joint press that worked great but it was still a job and a hard one. The new ball joints fit great,it was the old ones that were a problem to get out.
Sergio Cadiz
2025-02-22 13:06:34
Las partes son de buena calidad y funcionaron muy bien.
Thomas
2025-01-31 17:16:40
This product is too large to fit into the steering knuckle. I had to buy another set of ball joints. Don’t buy it if you have a Ranger 4x4 it doesn’t fit.
Anthony pham
2025-01-23 17:00:37
It fits but the grease cover is loose causing grease to leak out. The zerk fitting on the lower ball joint tears right off from axle spinning. I hope it last long
Josh Gunn
2024-12-20 14:27:24
Lowers fit fine, uppers are too short and will not allow the bushings be re-installed or the pinch bolt to go back in.
Billy Church
2024-12-16 14:46:15
Great balljoints ,just like factory original, not to bad to install with the right tools.
Recommended Products