Your cart is empty.
Your cart is empty.Product Description
Dennis
May 14, 2025
Used to remove overfilled transmission fluid out via dip stick tube. Worked well. Bit tight, but better tight than loose. Held up well. Unaffected by transmission fluid.
af
May 1, 2025
Not as nice as the mighty vac one but dam if it doesn’t do the job for a fraction of the price.
Dennis
April 28, 2025
I bought this to change power steering fluid. I should have just gotten a turkey baster. This is made for bigger extraction jobs. Still too hard to pull. Maybe lube it first.
Mario Galarza
April 26, 2025
The pump works perfectly no leaks good pressure but the initial first pump fells extremely hard had to put it on a vize to release the suction . And if it sits for a day or 2 it's way too much suction
Konto_von_mir
April 24, 2025
I already have a similar unit in 200ml, but when I remove extra coolant from a reservoir I have to use it up to 3-4 times occasionally after a vacuum fill of the system. This pump is for those type of jobs where you simply need a little extra capacity. It comes with different types of tubes and accessories. Very happy with the purchase so far!
Notfastenuf
April 9, 2025
Simple and effective design. My unit had been used before but didn't effect functionality. Good seal with redundant O-rings. Even includes a replacement pair of O-rings.The fitting for the extraction tubes only fits the larger tube so if you need the smaller tube, you must connect it to the large tube or cut a piece to use as an adapter.To test it out I used it to top off the water in a battery. Great size for the task and didn't have to spill water everywhere filling each cell. Only issue is the viscosity of the water was too low to stay in the tube and the full cylinder will drain out if left upright. Not a deal killer but a check valve would make this less susceptible to leakage and potential messes.
Rick Reed
March 3, 2025
Got stuck trying to suck
R. Hyder
February 12, 2025
After getting a similar device and finding out just how useful it is, it seems like I use one all the time. How did I not have one all these years.I have a diesel truck and each time I fill it with fuel, I add an additive. I buy the additive in gallon bottles, but have a smaller squeezable bottle with the measuring device at the top that I keep in the truck (much more convenient). But, it is difficult to refill that smaller bottle from the gallon container.This makes that much easier because it is easier to control.I just had to replace the calipers on my truck. While doing that, I wanted to completely replace the fluid from the Master Cylinder. This made that much easier to empty the MC and not get air in the lines and/or contaminate the new fluid with the old.I have a generator that I needed to fill with oil. The oil fill is not in the easiest place to reach. But this did it beautifully. I was even able to measure the amount I would be putting in when I pulled it from the bottle.Just a few of the uses I have experienced since I got one of these only a couple of months ago. How did I get along without one?I like this and recommend it.
Recommended Products