Your cart is empty.
Your cart is empty. Specification:
Color: black
Material: 45-gauge steel
Product Size:
nut/bearing assembly: 4.8x3.8x4.8cm/1.89x1.5x1.89in
M16x2.0 adapter: 21x1.3x1.3cm/8.26x0.51x0.51in
M12x1.75 adapter: 21x1.2x1.2cm/8.26x0.47x0.47in
M14x1.5 adapter: 23x1.3x1.3cm/9.05x0.51x0.51in
M12x1.5 adapter: 16.8x1.2x1.2cm/6.61x0.47x0.47in
Package details:
1 x nut/bearing assembly
1 x M16x2.0 adapter
1 x M12x1.75 adapter
1 x M14x1.5 adapter
1 x M12x1.5 adapter
Note:
Due to manual measurement, the size and weight may have a certain error.
Due to the difference between different monitors, there may be a slight color difference existed.
brian mccormick
2025-08-05 10:30:22
Works great on 2007 Chrysler Pacifica
Jmiller
2025-07-12 18:22:15
Description says that bolt 4 is an m12x1.5 and it is actually m12x1.75… unusable for ford.
Carrie
2025-03-31 18:04:27
Only gave 1 stars because I could not actually use the tool. Threads are not long enough for the Ford 4.0 motor. All the rods are based off of the M14 thread size and would not allow the rod to pass through the hole in the pulley. The bolt for the pulley is an M12 diameter. Used a rubber mallet and crankshaft bolt instead. Pictures included show the difference in lengths of the threads for the rod vs the bolt. I also included pictures of the rod which is about 3/4 of an inch short of reaching the end of the pulley, which is shown in the third picture. The bolt is almost flush with the end of the pulley. Would have been a good idea, but not for this motor.
dillon
2025-02-16 10:58:43
Works as it should defiantly recommend
George
2025-02-06 20:11:09
As another review has stated #4 bolt is incorrect in pitch. It is not a 1.5 pitch and will not work in a Ford 3.5 engine even though seller states it will.
Jeff Angus
2025-01-16 10:20:40
Worked great for pressing harmonic balancer onto my 5.7 Hemi !
Recommended Products
