Your cart is empty.
Your cart is empty.Product Description
Carburetor for Tecumseh HMSK80 HMSK90 8hp 9hp 10hp LH318SA LH358SA for Snow Blower Generator Chipper Shredder
Carburetor for Tecumseh 640054 640349 640058 640058A Oregon 50-659 STENS 520-926 models.
This carburetor is manufactured with the best finish craft, which prevents the metal from getting rusty, given the circumstance that the carburetor being working in gas fluid.
Compatible with:
Tecumseh Chipper Shredder 640349 640052 640054 640058 640058A
Tecumseh 8hp 9hp 10hp engines
HMSK80 HMSK90 Generators
Tecumseh Models HMSK100-159295W HMSK100-159297W HMSK100-159302W Snowblower Chipper
Tecumseh LH318SA LH358SA for Snow Blower Generator Chipper Shredder
John Deere Snow Blower Thrower TRX24 TRX26 TRX27 TRX32 TRS22 TRS24 TRS26 TRS27 TRS32 8 HP Units
Replace MFG # 5313 / 5002 / 5036 and OREGON 50-659
Replace STENS 520-926
It was pre-adjusted before shipping!
ADVICE: If you are not a mechanic, please take pictures on the carburetor's position before taking your old one off, so that you wouldn't forget how to install the new one!
High quality material in screws, fuel inlet, outlet and the choke.
This carburetor is a Bolt-on & Go carb, no adjustment needed!
Package Includes:
- 1x Carburetor as Pictured
- 1x Mounting Gasket
- 1x Fuel Filter
- 1x Primer Bulb
- 1x Fuel Line
- 1x Primer Line
- 1x Fuel Valve
- 1x Throttle Control Knob 35440
- 1x Throttle Control Knob 35438
Max
September 4, 2025
The parts fit well and operate well. Please note that you will need to transfer the choke lever mechanism from your original carburetor to this replacement. Your carburetor might also have optional brackets to support engine sheet metal. It is easier to swap out these parts prior to installing the new carburetor on your Snow Blower or whatever machine you are working on. Remember to be careful of all linkages for the throttle which is tied to the speed governor. This is a great part to get another decade or more out of equipment you already own.
LChamps
August 26, 2025
Owned a 26" snowblower since new in 1997 with HMSK80 engine, replaced multiple carbs and this one works best so far. Prior to this had an adjustable one, but could never get it just right. Replaced with this one and used the gasket + a short length of included tube, nothing else in the kit tested so far but all accessories are there if needed. Took a few minutes to prime, start and stabilize the first time, but then went on through its first snow storm for a full hour of good performance. Happy with purchase and would buy again a non-adjustable carb, recommended.
Chloe135
July 24, 2025
I replaced the original carburetor on my old Sears Craftsman 9HP snow thrower with this one. The installation of the carburetor was straight forward, and the engine started right up and runs excellent. No adjustments to the carburetor needed. I do agree with several reviewers that the included fuel line was a bit short. I purchased the new fuel line separately. I did like the fact that the packaged included a new vacuum line, a fuel shutoff, and fuel filter neither of which I had on the original. The price was just slightly more than the cost of a Tecumseh carb rebuild kit and without the mess of cleaning and repairing the old carburetor. I would definitely recommend this item to others. Saved $ with DIY.
Sparkie
July 22, 2025
My Ariens snowblower came with a Tecumseh HMSK80 carburetor. The gaskets leaked gas after 24 years of use, and OEM parts are no longer available. At $16 per kit, I bought two for a replacement. Fit was perfect including linkage interfaces. However, when I primed the carburetor, gas leaked out around the float bowl seal. The snowblower started and ran fine, and the leakage stopped while running. I repeated this sequence six times, with the same result. Conclusion: a) An inexpensive solution to get the snowblower up and running. b) The fuel bowl or other gaskets that leak gas when priming suggests inadequate factory gasket design / assembly. c) The factory setting for this carburetor was perfect for choke and idle speed. d) Check for any gas leakage below the carburetor before starting the snowblower.
Dennis Allen
July 20, 2025
Shipped in fast, I installed the carb. See this before, No Start (no fuel) at first, tapped in the carb fired right up. The float needle, I think was just stuck from sitting. Not my first rodeo on things like this. easy install. Would purchase again. nice kit.
t.d.ham
May 26, 2025
The kit was very complete with hose and accessories. Still bought better hose clamps. Bolted it on and fired it up. Work as it should.
Nicholas J.
April 22, 2025
Perfect fit and worked great for my Noma 10HP Tecumseh.
Shopper
April 18, 2025
An exact fit for my 2006 OEM Snow King snowblower engine. Started on the first pull, checked high and idle RPMs with a tachometer and they were spot on, no adjustment needed. Only used the carb, original fuel/primer lines and primer bulb were just fine, but good to have replacements for future needs. Quick and simple installation, no instructions so if you're skittish, look up your specific snowblower on Youtube and watch some of the many videos. Take pictures and note which hole the governor link uses, I marked the correct spot for the new one with a Sharpie before I started. You'll also use the original shield bracket and choke linkage, so be sure to note how they work. And do yourself a favor and use ONLY ethanol-free gas in small carbureted engines, mine was 12 years old when I got it, clearly the previous owner did not. I'll clean out the old carb at some point and put it on the shelf, but this was a hassle free, quick and efficient choice
christian
April 5, 2025
Fonctionne super bien
peter s.
March 24, 2025
my snowblower runs good now and it looks a good quality.
Oliver Audet
March 15, 2025
Works great. Nice kit. Can't beat the price
G tech
February 10, 2025
Fit 318cc craftsman snowblower
MMAE
January 14, 2025
This carb works just as I hoped & better than trying to get the old one to work having old fuel left in it for 8 years. The primer, hose & knobs were a bonus.
Recommended Products