Your cart is empty.
Your cart is empty.Nicolas A. Mills
2025-09-01 19:21:54
We used these to pull 4ga wires over 300 feet. Worked great! Good quality.
Teresa Feliu
2025-08-06 16:36:31
No complaint whatsoever. Used these to pull THHN cable through 40' runs of liquid tight flex cable.
hotfxr
2025-08-05 11:38:59
I had to pull a tight bunch of cables through 100' of PVC pipe and was worried that it might slip off or I would drop a couple of wires. Nope, it grabbed the bundle perfectly. Added bonus, it was real easy to remove.
Gregg
2025-07-30 14:22:26
These things made my job a millions times easier. I had to pull fiber optic cable through over 100 ft of conduit. Fiber optic is very sensitive to bending or tip damage. Using a normal fish tape if you were to try to connect it like normal wire it would damage the fiber optic. The way that this slips over the casing and grabs it and pulls the line dead straight is ideal for things like fiber optic. I'm sure it would work great for other things like Romex or cable TV line. Quick, easy connection and has a reinforced loop to slip over the end of the fish tape. For the cost of it it is really worth the money. I had the fiber optic company come out and it was the first time they had seen it or used it and they thought it was great because it made their jobs so much easier and quicker
Fred F
2025-07-19 20:18:40
If you ever need to pull wires (I pulled two coax- one with the connector on and a direct burial Cat six on one run with no problems. Used an existing line to pull a fishing tape and the fishing tape to pull the lines with the cable sock. 75 ft run in 1" conduit without issue.
Greg
2025-06-24 12:07:07
Makes pulling fiber optic cables through walls very easy.
TJNII
2025-05-27 15:25:49
I've been using these to pull multiple strands of THHN though PVC conduit and they work well. They bite good without damaging, and hold well, to the point of being somewhat difficult to remove after the pull. My last pull was 8 runs of #14 THHN though 20' of 1/2" conduit with 360 degrees of bends, and it pulled without any issue. I have found wrapping the very end of the wires with a few wraps of electrical tape does help to keep them bundled when putting the puller on and to keep the tips of the cables from poking through the mesh while pulling, but that's all that's needed.Much, much easier than trying to tape a wire bundle to a fish tape and pull that way.
Luiz
2025-05-04 16:40:32
They are functional and strong. But I need the 4-6mm and this is not it.
FermÃn Hernández
2025-04-23 14:37:31
Muy util
Francisco Morales Loera
2025-02-20 11:25:30
Es muy grande no es lo que nesecitoPuedo regresarlo
Yonni
2025-02-18 10:15:04
No sujeta los cables, fue un gasto innecesario
Recommended Products