Your cart is empty.
Your cart is empty.Lucas
2025-06-28 17:49:45
I had to remove the outer ridge in picture to get it into the socket on my truck. After that it went in snug and works as intended.
Craig Seager
2025-06-21 10:45:57
I bought a dash cam. It uses the regular fuses to plug in. My 2018 Ford Explorer uses the smaller (Micro 3) fuses. I needed a way to convert my power source to Micro 3. This is it! Arrived in a few short days and installed easily. Could not be happier. Just upset that I didn't think of this first. Genius. Take my money...
Ms Rose
2025-06-08 18:09:41
I got this to wire a digital rear view mirror into the fuse panel. It did that job admirably and without error. I've been running it now for months and have had no issues. I suppose I could be a bit quicker about writing the review.
MichiganJim
2025-05-22 20:54:17
Added an easy to access circuit to signal my light bar relay. Lights are now activated with the high beam switch with no load on the high beam circuit.
Munro Enterprises
2025-05-21 17:20:58
this is a hard to find part and I am happy with it, not a bad price
BeltzHaus
2025-03-02 14:18:18
Installed in a 2020 Ford Explorer. Definitely a tight fit in the fuse panel as others have mentioned. It was also so tight to plug a fuse into it that I broke the first fuse. The butt splice that it came with just fell off the wire so I had to replace that too.
Brian
2025-02-11 20:22:46
Thought these would easy, but they did not fit in my fusebox. As others have pointed out tge plastic is larger than the standard fuses. I started by using a Dremal to grind down the outside edges. I then had to grind down the front and back and finally got them to fit. They seem to work OK, once you get them to fit.
Lango
2025-02-04 19:49:04
If you’re planning to do any connections to the fuse box, these “add-a-fuses†are a must have.!
Recommended Products
