Your cart is empty.
Your cart is empty. Fits a male end 2.0" OD tube,Includes Latching Pin.
5,000 LBS support capacity.
Zinc plated, can be used on boat trailers;Stabilizes your jack.Easy installation.
Dylan
August 5, 2025
Fit perfect and as described. Looks quality, but time will tell how it lasts. makes unhooking your trailer super simple and less time turning the jack. very affordable compared to replacing the jack, and hides away nicely.
dalock
June 28, 2025
The product is sturdy and well made. However the holes are 90 degrees off from the holes in my trailer jack tube. I had to drill holes through my trailer jack tube at 90 degrees from the original in order to insert the pin. Also I had to grind the burrs from the inside of my trailer jack tube so this product would fit up into it. I like this longer foot because now I don't have to stack up so many boards to get my trailer level.
Dr. Dan
June 23, 2025
I can't complain about the quality as the extension appears to be solid and well made. However, it is not 1.71" outside diameter, but more like 1.74" to 1.745.That 3/100's of an inch matters when it is made to be a snug fit to start with....so be safe and measure first, using a caliper and not a tape measure since it does come down to fractions of an inch.For those wondering, it does NOT fit a Lippert 285318 3500LB Power Tongue Jack like I have on my camper. It's inside diameter is about 1.61".
J.Cleary
May 2, 2025
Installed it on my bush hog and it works perfectly as it should.
Don A
April 15, 2025
Great manufactured trailer jack tongue extension but it won't fit! This will NOT fit the 'newer' Lippert electric jack on a 2022 trailer. The outside of this extension is too large (1.71") and won't slide inside the Lippert Jack.
Kevin
April 10, 2025
Fits 2" trailer jack with crimp perfectly.
seck66
March 26, 2025
Purchased an off-road trailer with lots of ground clearance. It came with a poorly made wheel as a base. The wheel had a lot of "slop" in it and the base would shift and move. This was especially troublesome when the tongue jack was near the bottom or top of it's telescoping. This long base precluded the need for the jack to extend any further than a few inches in either direction. I still would recommend a block underneath it if you're setting up on rocky or uneven ground. I would recommend this product.
Coffee guy
February 15, 2025
This seems to be well made, but is too thick to fit a Lippert Smart Jack. Photo of label added.
John
December 11, 2024
A little bigger than the advertised 1.71 inch diameter and it has a welded seam on one side. I tried to insert it to the middle hole and it jammed about an inch short.If I can get it back out, I’ll try filing off the seam ridge and reinstall it.Wish me luck!
Recommended Products
$85.00
$ 34 .99 $34.99
$49.99
$ 26 .99 $26.99