Your cart is empty.
Your cart is empty.Converts electric motor to Grinder or Buffing machine. Fits 1/2" Motor Shafts. Converts 1/2" motor shaft to 1/2" Threaded shaft. Wheel Widths Up To 1 1/16 in. O.A.L. 3.50 in Washer Dia. 1.625 in Lock on to motor shaft with 2 hex set screws 1/2"-20 Left Hand thread. Holds Grinding wheels, Wire wheels or Buffing wheels with 1/2" hole
Beverly R.
2025-05-11 10:08:47
Arbor fits well on motor shaft,good quality. I called seller with a question and had very good response! The order was shipped same day, but from there it was all downhill.By NO fault of shipperUSPS was extremely slow, 15 days to arrive! I would request another carrier if your in a hurry.
show me state
2025-04-13 11:18:16
good product. I have purchased more of them from this company. but it has no where to put a wrench , to hold it when tightening the nut.
Stillh2os
2025-04-11 14:11:21
because the nuts tighten in the same direction as the shaft is turning and, therefore, it's impossible for the nuts to loosen while the shaft is in motion. Just hold the wheel or the adapter with your hand and tighten the nut with the other hand as much as you can, and that is as tight as it needs to be.
james
2025-04-06 10:01:28
The pictures show a right hand thread, but it's not. You have to look at the social features section at the bottom of the listing to find out it's left hand thread. What a joke. It was 4 days late arriving too.
BD
2025-02-19 10:40:39
The nut is left threaded but the fastening screws that hold the adapter to the shaft of the motor are right threaded and so the adapter become loose and wobbles. Doesn't make any sense.
StevenB
2025-02-04 13:51:37
Steel seems to be holding up well. Fits as specified. Would have a better rating if it was threaded to screw in addition to the set screws.
Recommended Products
$35.85
$ 16 .99 $16.99
$45.57
$ 19 .99 $19.99
$25.09
$ 11 .99 $11.99
$41.03
$ 19 .99 $19.99