- Home
-
All Categories
- Musical Instruments
- Home & Kitchen
- Electronics
- Tools & Home Improvement
- Toys & Games
- Industrial & Scientific
- Automotive
- Baby
- Sports & Outdoors
- Computers & Accessories
- Clothing, Shoes & Jewelry
- Office Products
- Pet Supplies
- Arts, Crafts & Sewing
- Kitchen & Dining
- Grocery & Gourmet Food
- Patio, Lawn & Garden
- Health & Household
- Appliances
- Cell Phones & Accessories
- Sports Collectibles
- Camera & Photo Products
- Payment
- About Us
- FAQ
- Privacy Notice
- Shipping & Returns
- Contact Us
Your cart is empty.
Your cart is empty.- Home /
- Industrial & Scientific
- Food Service Equipment & Supplies
- Industrial Electrical
- Abrasive & Finishing Products
- Material Handling Products
- Occupational Health & Safety Products
- Lab & Scientific Products
- Raw Materials
- Filtration
- Fasteners
- Janitorial & Sanitation Supplies
- Power Transmission Products
- Hydraulics, Pneumatics & Plumbing
- Cutting Tools
- Digital Signage
- Test, Measure & Inspect
- Packaging & Shipping Supplies
- Industrial Hardware
- Retail Store Fixtures & Equipment
- Adhesives, Sealants & Lubricants
- Additive Manufacturing Products
- Commercial Door Products
- Robotics
- Science Education
- Power & Hand Tools
/
- Industrial Electrical /
- Controls & Indicators /
- Relays /
- Electromechanical Relays
3V 1 Channel Relay Power Switch with Opto Isolation High Level Trigger
Optocoupler Isolator: 3V/3.3V power relay module supports photocoupler isolation control.
High Level Trigger: The relay module is triggered by a high-level signal(1.3V), which can be input from microcontroller IO.
Long Life: Fast response time less than 20ms and long lifetime up to 100,000 times snap action with diode freewheel protection.
Photocoupler Isolation Control
High Level Trigger
Long Life
Specifications
Working Voltage: DC 3-3.3V
Load: 10A 250VAC / 10A 30VDC
Working Current: 65mA
Trigger Current: 3mA
Load Current: 10A max
Single Socket Length: 7.5mm
Response Time:
Jumper Caps
JP1 is used to connect VCC of the signal terminals and V+ of the relay.
JP2 is used to connect GND of the signal terminals and V+ of the relay.
The high-level signal that over 1.3V to IN can trigger the relay.
$9.99 $9.99
$ 4 .99 $4.99
$7.99 $7.99
$ 3 .99 $3.99
$15.99 $15.99
$ 6 .99 $6.99
$42.00 $42.00
$ 18 .99 $18.99