Your cart is empty.
Your cart is empty.Aluminum water necks fit most Chevrolet V8’s. Two-piece design necks swivel 360 degrees to accommodate LH and RH radiator inlets. An O-ring seal and two chrome plated socket head cap screws are included.
Ddub
2025-08-10 12:28:36
Solid piece. Looks great! Will buy again. You can turn this piece any direction you want.
Lars E
2025-08-03 13:54:05
Good looking part, as I had hoped and expected from Allstar.
RoboCop1
2025-07-21 10:25:05
This product is a well-constructed and is value priced more favorably as compared to the billet versions I have used in the past.
Remi
2025-06-24 17:24:17
Great product. Fast delivery!
Dave Smith
2025-03-02 15:32:28
Thanks
Paul R
2024-12-08 15:59:12
I was looking to move my electric fan switch to another port in the intake manifold but the housing I had went right over top of the port so I needed a housing that I could pivot just a bit so it wasn't in the way of the sensor. I found this one online and it had a lot of good reviews on US sites but it was cheaper on Amazon.ca and I didn't have to deal with customs so I bought it here. Turns out it is a bit higher to the bend than the one I had so I didn't even really need the swivel feature as it cleared the sensor.Like it overall but I was a bit disappointed with the burring/flash from where the two molds meet inside the neck. The scratches were already in the neck so not sure about that. Not really a huge deal as I'm handy enough to use my rotary tool to clean it up but still could be better quality control.
Recommended Products
