Your cart is empty.
Your cart is empty.Allstar 36 inch Long x 2 inch 12-Gauge Steel Wide Axle Housing Truss Support for Ford 9 inch Model fits the Ford and measures 9 inches on it's differential models. The measurements are 36 inches long x 2 inches wide and is made from high-quality 12-gauge (. 108 inches) steel. The support adds strength to the rear axle housing and reduces unwanted flex during extreme torque. It is backed by a 90-day limited factory and sold individually.
benjamin
2025-08-09 10:10:21
nice little BACKBONE TRUSS. The steel it's made of is a little thin but good cuts and bends I have yet to install but will post a follow up review. The main thing is this is a back bone truss it welds to the back of the axle where the differential cover would be. It arrived within a week can't wait to put it on
Kyle
2025-07-24 13:23:11
The fitment was aweful. Couldn’t even trim it to save it. Had to throw it out and make a custom one
BIGStroker350
2025-06-17 14:59:35
Used to strengthen a ford 9 inch off a 80's f150 for a derby car. Welded right on good fit. Even took a hard shot from a bumper with no problems. I added some angle iron to support my mounts
glen forbes
2025-03-21 17:13:14
Fit was Spot on...and Goid Thickness...thanks
constantinos ratatsidis
2024-12-16 10:31:46
The brace is ok but I'm not sure I ordered the correct brace or not. Had to modify to fit properly on my 69 Bronco 9"
Recommended Products
$39.91
$ 20 .99 $20.99