Your cart is empty.
Your cart is empty.Allstar 4500 Type Series Open Center Carburetor Base Gasket (Pack of 10) is for 4500 type series carburetors and is an open center design. It is backed by a 90-day limited factory warranty. It is sold as one set of 10 pieces.
Steve
July 31, 2025
Need a 1/4" spacer to get rid of the Holley Sniper EFI whistle? This one will do it, and at a 1/4" thick it didn't cause hood clearance issues.
Robert Bonin
July 23, 2025
I was needing a new base gasket for my Holley 4500 carburetor; this was an exact fit and shipped faster than expected and was the right price.
Chris L
July 14, 2025
This is a good quality gasket. Used a pair under and over a wedge for a marine 4150 carburetor on a boat.
Rosemarie
July 4, 2025
ðŸ‘ðŸ»
DPG70
May 30, 2025
These gaskets measured .062, which is the same thickness as the Mr. Gasket units I am using now. The Mr. Gasket pieces are $4.49 for the 54G and $6.46 for the 54c EACH! I reviewed the .045 gaskets as usable if the mating surfaces are perfect. These .062 will work if the two surfaces are not perfect.
Corvettelen
March 23, 2025
Top quality, excellent machining perfect!
Jeff Jackson
February 13, 2025
Gasket was a little to thin for my application
pere
January 21, 2025
the product wasn't very good, is that adhering to the rules
Hobo
January 5, 2025
I don't write any bad reviews but this just frosted me. Paid $15 which is ridiculous for a gasket. Found out the holes needed to be enlarged because they were not centered. Took 1/8" off to the one side of every hole. It doesn't look anything like the picture. The skinny dividing portions were fat and needed to be cut away. Bought this for a Holley Sniper.... doesn't fit without hours of work.
Linda Larocque
December 21, 2024
Holes don't match..they're offset..not centered to the carburator
Recommended Products
