Your cart is empty.
Your cart is empty.Industrial brad point boring bits are coated with a non-stick coating for longer lasting cutting edge and tool life.Amana tool dowel drills are coated with a special polytetrafluoroethylene (PTFE), a non-stick color coating. In cases where the carbide tip cutting edges are coated, there is No need to sand the coating off before use. Once the tool starts drilling, The coating is cleared off the needed cutting edge right away, #204005, (B) Cutting height: 35mm, (D) diameter: 5mm, (D) shank: 10mm, Overall Length (L): 70mm, rotation: right hand204005 carbide Tipped brad point boring bit r/H 5mm DIA x 70mm long x 10mm Shank
Ole H.
2025-06-12 21:24:34
Will stay sharp for a great many holes! Yes, would buy again. Amana has excellent products.
billy wickey
2025-06-08 19:29:24
I USE THIS BIT FOR DRILLING MULTIPLE SERIES OF HOLES FOR ADJUSTABLE SHELVES FOR THECABINETS I BUILD
Alex
2025-05-17 19:21:41
Thanks
bill richards
2025-04-24 18:04:57
value is good. works well. clean holes.
Memo's Fine Cabinetry inc.
2025-04-06 11:13:37
Excellent!!!!
BuddyGuy
2025-03-29 19:44:37
bueno
Otokoyama Denki
2025-02-28 10:18:38
This *really* struggles to get through soft wood, becoming very hot and not leaving a clean hole, as if it isn’t at all sharp. Other brad point drills are quick, and cut a clean hole through to the back. Also, the central point isn’t long enough to center it well.
JosepH fITZGERALD
2025-02-26 09:40:12
Didn’t fit in a m10 shaft! The flattened grind was not deep enough.
Brent B.
2025-02-07 13:56:55
Just as advertised, works very good, clean holes.
Recommended Products
