Your cart is empty.
Your cart is empty.Product Description
Paul Byrd
2025-08-29 11:20:48
Used as feet on the cabinet of a vintage Rockwell 12" disc sander. Makes it nice and stable. Good value.
BML
2025-08-28 18:01:31
These universal anti-vibration pads are perfect for isolating your mini splits vibrations. The rubber pads work fine with a little alteration for the mini split wall mount I used. The pads are nice and thick and the captured bolt works fine and held securely. I think I am going to order another for my other unit. They had a huge rubber and chemical smell when I first unboxed them but since they are outdoor it should not be an issue.
TravisM
2025-08-20 16:11:37
Unfortunately, my 24k bts unit was just the max size to fit my wall brackets without the isolates as it turnea out. The added width of these isolates was too much to fit on my brackets. They add an extra 1.5in on each side of the mounts (so 3in in total).The wall anchored look good and its nice they include extra.I was a little disappointed with the construction. They didn't have any metal core or support inside. They are just a hunk of rubber. Not sure how long they would last in the sun but if the rubber fails, the hole mount fails since there is no core. Probably not a huge deal if the unit is on the ground or near the ground.
Allison
2025-08-13 17:11:10
vibration isolators on large even huge equipment I can say these are CUTE! LolBut seriously, these rubber vibration isolators and the included hardware is good quality. This kit will protect your equipment from wear and tear and will keep any transferred vibration away.Tip: after installing make sure the equipment you used this kit on is level. Front to back and side to side.
christopher.robot
2025-08-10 16:29:21
Mounted my compressor motor with these - really cuts down on the racket
toleegit
2025-05-04 14:37:39
Works well - no vibrations. Easy to use - easy to install
John P
2025-03-09 16:16:04
So far these are working well with a 33,000 BTU mini split condenser. I did had to modify all four of then so that the fit properly. The out top edge interfered with the foot of my unit. Cutting off a small piece solved the problem. They cut very easily with an oscillating saw. The stud on top is just the correct length.Reasonably priced.
Molly Hunt
2025-01-05 15:59:10
work well, good value for the money, fit on my della minisplits, super easy to use and reduce noise and vibrations.
Recommended Products