Your cart is empty.
Your cart is empty.Product Description
Pwilly
2025-09-05 17:58:00
Fit perfectly. I recommend propane torch heating the old bolts if really rusty... preventing breaking and causing big head ACHE! Pinch hose clamps and a wiggle and old ones came right off. 20min repair if you good! Will leak a little fluid be quick!
Browns A.
2025-09-02 11:34:02
No, it does not fit perfectly on a Tacoma BUT! Bolt holes perfect and 3 of 4 tubes are just fine. Tube to hose going up to radiator had to be bent differently to clear from rubbing against things. That is to be expected since it is not supposed to fit the Tacoma body style. From the dealer it cost over 100 dollars! I think it’s great!
Justin
2025-08-10 12:26:46
My old pipes rusted out and were leaking. This bolted right up. Was a little tricky to get the hoses disconnected but not too bad of a job. Took about an hour to replace.
Wendy S Schmidt
2025-05-30 12:51:52
Exactly like it should be
Zach
2025-04-28 17:48:11
Installed these lines on a 2008 FJ Cruiser. They immediately started leaking from the welds on the bracket when I started the vehicle. Don’t waste your time or money on these lines.
Customer
2025-03-23 16:52:16
This will replace original lines on a 2007 v8 4.7l
DON MARTIN
2025-01-09 09:23:18
THIS PRODUCT IS A1 IT FITTED GREAT THANK YOU DON...
AK
2024-12-31 15:05:02
mounts are spaced differently for the 2011 FJbut itll fit above the mount bar with zip ties to get you homeyou could re drill for bolting downthese hoses are a bit shorter but you can cut the rubber hose a bit and still reachget clamps yours are probably going to break when you try to take them off (rusty)it wasnt much of a fight, the hose diameter are still right (5/16..... 3/8 works)took about an hour....dont mix up which line is which pictures are online to check if you needthis is a common problem leak point from rusting metal linespaint them to help them last
Recommended Products
$37.05
$ 16 .99 $16.99