Your cart is empty.
Your cart is empty.Product Description
Scott Smith
2025-08-28 16:10:30
Fast shipping. No damage. Came with the oil and transmission cooler adapters. It's running great and installed perfectly. Great value and I'm satisfied.
Timothy J
2025-08-05 12:38:10
The radiator fit my Suburban perfectly, It seems more sturdy than the one I took out, but I am not absolutely sure, since I put it in the car as fast as I could. If I hadn't had to rely on YouTube videos, I would probably gotten it installed in an hour or so, but I did and it took most of a day to finish the removal, addition, and replacement of the stuff. There was a lot of stuff to remove, so if you get one, be careful not to lose any parts, like I did with one of the clamps
Customer
2025-07-05 18:47:16
Poor quality. Had a hard time getting transmission cooler line fittings to seal on installation. Lasted less then 6 months before it started leaking coolant from where the tank meets the core.
Mario
2025-06-12 13:34:52
When I opened the box I found small dents on the fins I just crossed my fingers and hope that it didn’t have hole on it. For the most part it did not leak it’s been about a week driving it without issues. Perfect size for my 5.3 trans cooler lines on radiator like I asked for. So far so good I will update in a month.cause I drive it a lot and it’s flipping cold so it’s going to work a little harder but great radiator so far. Thank youUpdate: no leaks and is working great I recommend this radiator..
Tim
2025-06-11 15:19:47
Fit perfectly and has 18 fins per inch which is good.
Shawnathon
2025-06-06 17:46:22
Bought this for my 07-13 Silverado 5.3L. It was an exact replacement and actually has a drain plug whereas the factory does not. Plug is on the lower drivers side! It came with new transmission line fittings and clips also. I did have to take the mounting rubber bushings off the old radiator but that’s no problem at all. Push them out of the top mounts with a flat edge screwdriver then the bottom mounts has a tab you push and slide off old bushings. Slip them back on the new one. Entire project took me maybe 2 hours tops including refilling and burping system. I’m on the second day of install and so far so good. Will retouch back after awhile with update. Happy so far!Update: almost 2 months later and still doing great! No leaks no probs
Customer
2025-05-19 12:35:59
Fit perfectly works great
Crystal
2025-05-12 18:10:10
The media could not be loaded.
Scott Smith
2025-05-11 10:50:56
Fast shipping. No damage. Came with the oil and transmission cooler adapters. It's running great and installed perfectly. Great value and I'm satisfied.
Timothy J
2025-03-28 18:50:45
The radiator fit my Suburban perfectly, It seems more sturdy than the one I took out, but I am not absolutely sure, since I put it in the car as fast as I could. If I hadn't had to rely on YouTube videos, I would probably gotten it installed in an hour or so, but I did and it took most of a day to finish the removal, addition, and replacement of the stuff. There was a lot of stuff to remove, so if you get one, be careful not to lose any parts, like I did with one of the clamps
Customer
2025-03-10 19:31:59
Poor quality. Had a hard time getting transmission cooler line fittings to seal on installation. Lasted less then 6 months before it started leaking coolant from where the tank meets the core.
Mario
2025-02-22 12:32:15
When I opened the box I found small dents on the fins I just crossed my fingers and hope that it didn’t have hole on it. For the most part it did not leak it’s been about a week driving it without issues. Perfect size for my 5.3 trans cooler lines on radiator like I asked for. So far so good I will update in a month.cause I drive it a lot and it’s flipping cold so it’s going to work a little harder but great radiator so far. Thank youUpdate: no leaks and is working great I recommend this radiator..
Tim
2025-01-15 20:35:39
Fit perfectly and has 18 fins per inch which is good.
Shawnathon
2024-12-02 12:07:31
Bought this for my 07-13 Silverado 5.3L. It was an exact replacement and actually has a drain plug whereas the factory does not. Plug is on the lower drivers side! It came with new transmission line fittings and clips also. I did have to take the mounting rubber bushings off the old radiator but that’s no problem at all. Push them out of the top mounts with a flat edge screwdriver then the bottom mounts has a tab you push and slide off old bushings. Slip them back on the new one. Entire project took me maybe 2 hours tops including refilling and burping system. I’m on the second day of install and so far so good. Will retouch back after awhile with update. Happy so far!Update: almost 2 months later and still doing great! No leaks no probs
Customer
2024-11-27 15:50:26
Fit perfectly works great
Crystal
2024-11-21 18:09:57
The media could not be loaded.
Recommended Products