Your cart is empty.
Your cart is empty.Irod
2025-08-31 21:19:31
Time will tell how long they will last. I was replacing the clutch on my 2006 toyota corolla and decided to replace the mounts. The rear motor mount does have the rubber heat shield
David Gaines
2025-07-23 11:11:05
What a great price. It probably won’t stay that way now. Trump’s in office.
jose rivera
2025-07-20 16:51:18
Perfect feet
Francisco M.
2025-07-14 09:00:30
A pesar del precio son de buena calidad
Darwin
2025-06-16 12:12:32
He usado múltiples repuestos de esta marca y son muy bueno, de muy buena calidad y duraderos.
DJ
2025-05-26 18:35:21
For the price they seem to be good mounts. It's been a few months and everything is still holding up fine
Rodrigo N.
2025-05-13 13:59:41
The part has good rubber and strong metal, BUT, for the worse it has manufacture defect, the RH (passenger side) mount does not fit in place, if you dont a have a special tool to open more gap on the holes that goes to the frame/body you will lose your time. Ended up putting the old one again and bought a quality part that matched perfectly. Didn't even try with the other mounts.
Customer
2025-04-11 16:20:10
allways a great parts bought three times all parts have been super great almost dealer quality
Customer
2025-04-01 12:14:43
All four motor mounts fit my 2010 Toyota Corolla 1.8 litre. The most difficult one to install was the rear transmission mount but the bolt pattern was exact match
Octavio S.
2025-03-15 17:17:10
El producto se ve de calidad, acordé al precio, ya las instalamos sin ningún contratiempo, todas encajaron bien. En el auto Corolla S 2006. están funcionando bien.
Mike
2025-01-26 11:18:19
None of the mounts came with new hardware, so the choices are either use the old, corroded hardware, get extorted at the dealer (Toyota), or go to a nuts and bolts store and try to find equivalent hardware.Three out of the four mounts seem to be OK, but the passenger-side engine mount was a colossal fail. With the mount in question, the OEM hardware didn't fit. The studs on the mount were ever so slightly too small. Not small enough to be a different size, but small enough that though the treads of the nuts engaged on the stud, the nuts still rocked on the studs. I figured I'd use them anyways as the torque spec is only 32 ft lb. But, before it reached the proper torque the first stud sheered off.So, I uninstalled the mount, removed both studs, went back to the fastener store (40 min away), bought new hardware, drilled out and tapped larger holes in said engine mount, drilled out the mounting plate on the engine (b/c now the new hardware was just a bit too big for the stock holes), and reinstalled said engine mount.Because it was made with subpar materials, a job that should have taken and hour or two ended up taking two days . . .
Anon
2025-01-04 18:27:33
Just installed them. No idea how long they will last. It turns out that the originsl mounts where in ok condition after 16 years. Only one (the rear mount) showed some small cracks. Experienced slight vibration when idle at stop and in drive or rearing gears. No vibration when idling in neutral.
Luis T
2025-01-03 16:45:15
Es un buen producto con hule de buena calidad aunque el acabado no es con la calidad que se muestra en la página.
Recommended Products