Your cart is empty.
Your cart is empty.Product Description
jjshipe
2025-08-31 12:16:51
Perfect fit, great price, fast arrival. Would have liked to have had a new pinch bolt with it.Great quality, clean and accurate
Jim S
2025-08-18 15:27:04
Messed the original up doing some diy car mechanic work and this worked perfectly as a replacement.
steve carson
2025-07-26 17:25:13
I purchased left and right knuckles for my 2014 Impreza. They fit perfectly and worked perfectly. The steering knuckle from Subaru was about $330. I measured this one and compared it to the old one and it was spot on. I would buy this every time for almost a tenth of the cost of the factory part !!
Vidal M
2025-07-22 10:35:07
Just buy it!
ldouglas
2025-06-30 17:19:10
It's a big hunk of metal, it fits, everything bolted up and sensors snapped in, it's just metal, nothing special.Replacement for the OEM one that I spent 5 hours trying to get the snapped ball joint bolt out on. After completely messing up from drilling out the bolt, I quickly ordered from Amazon. One day later, I had everything bolted up and ready to drive within 2 hours. 10,000 miles later it is still holding up.
Grant P
2025-06-23 10:17:16
Worked well for my 2010 subaru outback. Fit as to be expected, areas that were machined looked nice and the coating looked nice as well. I did notice that it weighed less than the OEM part so that would be only minor complaint. Have put some miles on them and everything is working well.
Customer
2025-06-01 20:03:15
Shipped fast, correct order, fit properly.
josh
2025-05-02 20:15:41
Good replacement for 09 Subaru forester
jean-guy duguay
2025-04-26 13:18:29
compatibilite parfaite avec subaru forester 2010 .Montage tres facile
Customer
2025-03-24 18:49:06
Nice
Randy Van Puyenbroeck
2025-03-15 15:49:46
While replacing CV axle and lower control arms I ran into a problem removing siezed ball joint due to excessive rust. Found this pair of knuckles for a great price, they fit perfectly and made the whole repair job way easier!
Jobingnuzzlenut
2025-02-08 15:45:57
This was a perfect replacement part for a fully worn 200K mile 2014 Subaru Outback knuckle that had a frozen pinch bolt and ball joint. The biggest concern was the cam adjustment bolt on the shock mounts would be off. After marking the location on the cam adjustment bolt head it fit and adjusted to a fraction of what it was. The tie rod end fit perfectly also.
dave marks
2025-02-03 13:43:00
Bolted in perfectly.I replaced my entire front end....and something is clicking when hitting bumps.It could be the new struts but I suspect a ball joint??
Recommended Products