Your cart is empty.
Your cart is empty.The Vacuum / Vac Lock is a safety mechanism designed with a spring action cover which holds the pool cleaner hose in place and will snap close the suction fitting automatically when not in use. It can be used with all suction pool cleaners such as the Hayward Pool Vac, Navigator, Baracuda, Kreepy Krauly and many other suction pool cleaners. ***Installation instruction: 1. Add silicone sealant to 1 1/2" male threads and hand turn into 1 1/2" female thread wall fitting already installed in the pool. This fitting will be connected to the suction side of the plumbing system with a 3-away or ball valve at the equipment to adjust the flow rate. 2. Thread into wall fitting as far as you can AND with the "arrow marking" pointing up. the spring will be on top. 3. Anchor set screw. 4. Use screwdriver to open flap and then insert vacuum/pool cleaner hose. "Clip" inside flap will help hold vacuum/pool cleaner hose to wall fitting when pump is turned off. 5. When not in use make sure cover flap has been snapped firmly in place. 6. NEVER operate a pool/spa with an uncovered suction outlet or vacuum port.***
Delcat
2025-09-06 11:22:07
Easy to replace and fit perfectly. Much cheaper than ordering from my pool company.
Tina Swartz
2025-06-11 17:14:16
This was cheap and fit perfectly and easily into my vacuum port!
Just me
2025-05-13 18:32:08
Well built, screws perfectly in the cleaner port on the wall of the pool. Vacuum hose fits in well and gets clipped and held in place by the lid.
Fernando Crissien
2025-01-18 16:01:21
It was a perfect fit!
AZT Kid
2025-01-12 10:37:07
Part drops right into place. No problems.
JEH
2024-12-27 18:55:23
This pool cleaner wall fitting is higher quality than the original which broke.
Mike
2024-12-04 16:15:32
Needed to replace 36 year old Hayward vac port because the spring rusted and broke. Fit and finish as ordered, worked fine. Spring is weak and failed holding the hose in use. Added some rubber bands to add seal to the hose and one holding the cover edge tighter to the hose. Could use one with a stronger spring.
Jon Donson
2024-11-15 16:10:49
re this replacement valve went in Easily enough. My frustration is it's somewhat difficult to pop the suction valve open...
Recommended Products
