Your cart is empty.
Your cart is empty.Ball stud's wear and over time require There is no way to repair a worn ball stud, it must be replaced with a new part. ATP ball studs are designed to fit and function just like the original part. This ball stud is popular on many 1988-95 GM C, K, and P Series trucks.
James Farmer Sr
2025-09-06 18:25:40
Very happy quality looked as good or better then the oem and so far no issues and I do alot of chevy trucks that require good partsWill be buying more In the near future5 🌟On Quality, Performance, and value!
Christian Prate
2025-09-05 16:09:56
Works great
Ken Stein
2025-09-01 10:26:55
The threaded tip that retains the fork on the pivot ball was staked in place, which is fine if it is done right but it wasn't. The staking displaced so much metal that it would have galled the fork pivot socket if I had not filed it down before install. There were also MANY machining and handling defects in the threads, chiefly machining defects around the groove for the grease port on the side of the stud and many dings and dents across the threads that would have damaged the threads of the cast aluminum bellhousing if I had just blindly threaded it in instead of inspecting it and using a thread file to clear them all.I'll buy any other brand next time, there is no reason I should have to spend 30 minutes correcting manufacturer issues on an OEM fitment part I paid for.
Vince
2025-07-21 15:47:17
Good quality, perfect fit.
William
2025-07-13 12:36:22
Perfect fit
Kate
2025-07-07 12:42:01
No issues, simple swap
Jason Dunbar
2025-07-06 10:07:16
Nice part
randall s burnett
2025-06-21 16:28:46
Works great
James Farmer Sr
2025-05-28 17:27:58
Very happy quality looked as good or better then the oem and so far no issues and I do alot of chevy trucks that require good partsWill be buying more In the near future5 🌟On Quality, Performance, and value!
Christian Prate
2025-05-05 18:06:16
Works great
Ken Stein
2025-04-27 17:13:00
The threaded tip that retains the fork on the pivot ball was staked in place, which is fine if it is done right but it wasn't. The staking displaced so much metal that it would have galled the fork pivot socket if I had not filed it down before install. There were also MANY machining and handling defects in the threads, chiefly machining defects around the groove for the grease port on the side of the stud and many dings and dents across the threads that would have damaged the threads of the cast aluminum bellhousing if I had just blindly threaded it in instead of inspecting it and using a thread file to clear them all.I'll buy any other brand next time, there is no reason I should have to spend 30 minutes correcting manufacturer issues on an OEM fitment part I paid for.
Vince
2025-04-10 10:49:55
Good quality, perfect fit.
William
2025-03-13 15:41:10
Perfect fit
Kate
2025-02-27 17:15:09
No issues, simple swap
Jason Dunbar
2025-02-16 10:38:23
Nice part
randall s burnett
2025-01-19 10:32:02
Works great
Recommended Products
