Your cart is empty.
Your cart is empty.Product Description
Free cutting
Soft and clear
Removing without trace
Please Read In Detail Before Purchasing
Q1: Will removing it damage the tabletop?
A1: Normally, it will not damage your furniture. However if your furniture is covered with paper laminate or those that are prone to paint loss, I would not recommend you to install it on this furniture as the adhesive is very sticky and you may damage the furniture.
Q2: How can I remove them without damaging the table or the walls?
A2: If you want to remove it, do not tear it off directly. Please use a hairdryer or heat gun to soften the tape first (not too hot) and then tear it off slowly to prevent tearing the tabletop or wall. If for some reason, there is still glue residue, we recommend rubbing a few drops of olive or vegetable oil or hot water on it and then wiping with a cloth. This may have to be repeated once or twice. We do not recommend using other solvents.
Q3: What are the unsuitable materials for bumper tapes?
A3: Table corner edge protection is suitable for clean and smooth flat surfaces. It is not suitable for plaster surfaces, paper surfaces, diatomaceous earth, untreated wood, sink tops, and other uneven surfaces. If you are of one of the above materials, I would not recommend that you install it on these pieces of furniture as the adhesive is very sticky and you could damage the furniture.
Very important:
Pls, refer to our concise installation video on our listing before you install our item. It can help you
avoid stretch and wrinkle when ripping off the layer of the double-sided tape or avoid getting loose
when installing our bumper strip.
In case you found your bumper strip getting loose after several days you installed it for some unexpected causes, (like didn't install pretty well )
don't worry, just compress it again, it will keep firmly stick to the table and protect your baby continuously, our double-sided tape's lifetime will last over three years.
Package included:
1x Corner Guards Bumper Strip 20ft(6m)
1x Double-sided tape 46ft(14m)
1x Right-angle Tool
1x Scraper Tool
Tony Bones
2025-08-26 11:45:06
The Silicon edge guard is great for desks. We picked up a new desk from Office Depot that looked great online only to find they were not made of real wood. Rather its a very thin film with a picture of wood. Its glued to composite board. The wood would scratch super easy and the edges got nicked every time the chair hit the desk. We should have installed the edge guard as soon as we put the desk together. This silicon kit has everything you need to install the guard and its not exactly hard. But you do need to clean both surfaces, a steady hand putting on the double sided tape and a good eye to keep the silicon straight while laying it on top of the tape. I measured the silicon and cut it to size. After cleaning the surface I put on the tape slowly trying not to stretch it while going in a straight line - 6" at a time. Used the included plastic straight edge tool I flatten the tape against the desk getting as many air bubbles out as possible. Then starting at a inside corner I pulled 6" of tape off and using a steel ruler (to keep guard straight) laid down the silicon guard. When I didnt use the ruler - the guard went down with waves as I pressed it down. Once I finished attaching about 6" of guard on the tape I wiped a little WD40 on the plastic corner tool (to help it slide) and gently pressed the silicon down on top of the tape. That removed bubbles and made sure it made good tape contact. Even being careful the silicon somehow got stretched out a bit and was longer than it needed to be. I let it setup like that for a day before trimming it to the right size in case it decided to shrink back to its original size. My first edge didn't look great but the other edges came out much better once I got the hang of it. Hope this helps.
Dee-Dee Webb
2025-08-04 17:25:23
I ordered an amazing glass/mirror two-level coffee table from Amazon and I didn't want to hide the beauty of it by placing the brown or white bumpers on it to protect my toddler grandchildren, but I had to do something. The clear bumper strips were a dream come true. I ordered the 20ft strip and the product was as described. The glue roll was a little tricky and frustrating at times, but the instructions makes it very clear to be careful when applying; hence the bubbles under the strips in the pictures.The strip was very flexible and soft, which made it easy to cut for the sizes I needed. I was able to cover all four sides of the top of the table and three of the sides on the bottom. I used the little that what was left to cover the sharp edges on the leg of the table (see picture).I am very happy with this product and have ordered another 20ft roll to cover the other side of the bottom of the coffee table and the matching end table I just ordered. Highly recommend.
JB
2025-07-17 20:37:13
This was a pain to put on until I realized that you had to lay the STICKY SHTUFF FIRST! On whatever surface you’re putting these on. Once they’re set though, they’re great. And look nice too actually.One thing though is if you really want them to stay..use the hell out of that yellow “spreader/putty knife†thing. And when I say use it, I mean, you gotta lean into it hard. It’s basically pressing out all the air bubbles while spreading the adhesive throughout.Great product though, love it.
Nae
2025-07-16 11:04:13
I purchased this item despite reading that it has been frequently returned. I also saw reviews stating that it does not stick well, but still gave it a chance. Well, it definitely does not stick well and I am sad that I purchased this item. I definitely regret it.On top of having to put the adhesive strip on the plastic yourself then the tape is halfway falling off as so as you apply it. This is something thats supposed to baby proof corners but is definitely not reliable. Look for a better product than this one.
Louis Trapani
2025-07-14 16:46:44
It’s been a couple of weeks and so far, so good. I am not sure how it will hold up in the long term (whether it will yellow over time or lose adhesion). Time will tell. My biggest problem was with the adhesive method. It is in a roll and you need to apply it to the surface from the roll. The problem I had was that at points in the roll it was sticking to itself as I unraveled the roll and the glue would stretch itself out as it stuck to itself causing an uneven application on the surface. So you would have globs of glue in certain areas or areas where the glue would be coming out from under the protector. Since it is a clear protector, you can see all the imperfections of the adhesive even once completed. So it looks a little sloppy. With that said, so far, it is doing its job giving me the protection on the edge of the countertop I applied it to now. If only they could prevent the glue from sticking to itself in the roll, I would probably give it 5 stars.
Amanda
2025-06-10 19:03:22
These are great because it’s cut to size and reusable
Nancy
2025-05-08 10:08:39
They are as described for safety on wall corners, coffee table etc.
david
2025-03-22 16:11:21
Buen producto el pegamento q trae la cinta es muy bueno, sobre todo la protección q brinda
nora alalem
2025-03-15 11:00:50
Unfortunately poor quality adhesive does not stick well at all
Ahmed Mohamed
2025-02-09 12:52:07
Very useful
London Customer
2025-01-08 11:21:31
Was intentionally looking for a "cut-to-purpose" one, as this way the thing becomes more functional and universal: you can stick it to sofa's / bed's legs too, for example - makes the impact with your foot fingers softer. Yes, it sort of makes sharp edges less sharp, it's not a cushion.Followed the instructions when sticking in up, everything holds. Now even tried using just small pieces of tape for the bottom side (one of the photos shows it, though it's difficult to see) - also holds, just make sure you fix it well on both ends, no need to pull as you stick it on.Tried removing on a small piece of wooden table - all fine, will be careful when removing longer ones anyway.
Recommended Products