Your cart is empty.
Your cart is empty.Since 1983 Belltech engineers developed one of the industry firsts that enabled the Sport Truck craze, the Belltech Drop Spindle. By relocating the wheel mounting point a.k.a. spindle pin or hub higher on the spindle casting, our engineers were able to provide a 2-3" lowering without affecting any other suspension or steering geometry. Belltech Drop Spindles offer a 2 or 3 inch drop depending on the application, while improving handling and retaining factory ride quality. Belltech spindles maintain critical suspension geometry and eliminate excessive ball joint, shock and tire wear common to other methods of lowering. Each spindle is built from OEM grade high strength ductile iron, providing the structural integrity to meet and exceed all factory specifications & requirements.
Mark Reeder
July 30, 2025
Prefect fit for 91-96 Caprice/Impala.I have a set on my 94 Caprice that came with Impala stocks and the turn radius is HORRID. It states on their sight that they are not compatible. I purchased a set to go on my bagged 95 Impala as well
JayDee240
January 30, 2025
I used these on a 1974 Camaro. They should fit any front steer Nova, Camaro, Firebird.
Andrew D.
November 12, 2024
I bought these spindles off summit to put on my racecar and got barely bumped on the driver side and thought my tie rod end broke or was bent under further inspection I found that the steering arm had broke clean off the spindle it didn’t even bend the tie rod looks like cast pot metal on the inside I will post pictures in the next few days
Recommended Products
