Your cart is empty.
Your cart is empty.Beveled Square Washers in plain iron are often used for leveling and shimming purposes, especially on an I-beam's flange where the bevel provides a parallel bearing surface.
Joe blackwell
2025-06-16 13:21:10
Great product
Nate
2025-05-31 10:36:39
Great tapered washers that provide flat surface when used with bolted fasteners to attach structural channel iron together and to other components.
happy shopper
2025-05-20 16:45:43
I had some edge anchors that got installed at an angle due to rebar being in the way. Anyway, the engineer said I needed to use wedge anchors so I searched and found these. I’m pleased and the engineer signed off on fix.
Vene Carvalho
2025-02-16 10:59:14
Used to provide a flat area to tighten hardware where the surfaces are angled. Cheap price. Rapid shipping
Dusty D
2025-02-08 12:39:16
They’re heavy duty. I used two of them to support a master cylinder at an angle on a car project.
PNW Shopper
2025-01-01 15:45:05
I needed bevel washers to give our patio chairs a slight tilt back to correct a terribly uncomfortable upright posture. These were the smallest physical dimension washers available. The chairs needed 2 sitting side by side but that wouldn't allow the bolt holes to line up. I corrected the problem by enlarging the washer bolt holes with a step bit so that there was enough slop that they'd fit together. Problem solved.
T. Steen
2024-12-01 11:22:01
These work nice on a snowmobile trailer where I need to bolt to a channel.
Recommended Products
