Your cart is empty.
Your cart is empty.Vintage Forge Black Flat Bottom Tapered Humbucking Pickup Mounting Rings Set compatible with Gibson USA Les Paul, SG and other similar guitars. Includes (1) Neck position ring and (1) Bridge position ring. We have found these rings to be a great replacement compatible with Gibson USA guitars but it is very important that you measure your existing rings and mounting hole spacing first to be sure! *These are not compatible with most Epiphone guitars (see our other listings.) Features: (2) High quality plastic rings in Black finish Complete set includes both Neck and Bridge position rings Flat bottoms w/tapered sides Easy to install - screws sold seperatley Vintage Forge Factory Sealed Packaging Part #HR2020F-BLK
JGF
2025-09-01 14:57:18
After a long search, I finally came across the correct size for my ESP LTD F-2005 Guitar with EMG-81's. Since I bought the guitar second hand in 2006, the original rings arrived broken, and over time got worst to the point I could not play the guitar anymore. I finally decided to repair it and these rings were exactly what I was looking for. Great quality, correct size. Thank you.
Zeroâž³
2025-08-31 21:41:48
I'm doing a PRS SE, and these are the nicest ones I've seen.Actually, nicer than the ones that came on the guitar.Vintage Forge are the Cadillac of rings. Holes are perfect.
Customer
2025-08-18 17:41:24
I changed all of the hardware and electronics on a brand new, out of the box, Epiphone Sheraton II Pro. The zebra pickups are factory uncovered Epiphone Probucker 2 and 3 that I purchased here on Amazon. These pickups are a total bargain for anyone looking to change the color scheme of their Sheraton while maintaining the factory sound. The Sheraton, I am told, can be purchased with any color hardware, as long as it is gold.The Vintage Forge flat pickup trim rings were the only ones I could find that fit the factory holes on the Epiphone. Additionally, the factory black trim rings were much thinner than these and I couldn't adjust the pickups high enough. The extra thickness of the Vintage Forge trim rings allowed me to easily raise both pickups up to the desired height.These are "flat" trim rings and are apparently intended to be sculpted to the guitar's contours. I found, in this case, they fit pretty well without shaping so I left them as is.My only fault is that the color of the Vintage Forge accessory plastic pieces is apparently not consistent across products, at least not for "cream". I also purchased a set of Vintage Forge cream speed knobs and they are not even close. The knobs look more like yellow and I can't use them. The trim rings are staying on the guitar however.
Danie
2025-06-17 18:05:23
Â
JC
2025-05-21 11:35:47
Did not fit a Dean Vendetta, way too narrow/small.
Customer
2025-04-24 13:23:51
Plastic, and cheap. Works fine. Just don't overtighten your screws or it will break the plastic. Cheers.
dissatisfied reader
2025-03-23 11:53:58
Just what I needed for my Schecter Hellraiser, perfect fit
mark b.
2025-02-09 16:37:16
Perfect. Just the color and fit I was looking for.
Max Provost
2025-01-21 13:35:50
Does what original parts would do for a fraction
Customer
2025-01-18 13:57:09
fit a Ibanez sz320. Wanted to order again but price increased by double of what i paid
Jeff
2024-12-19 15:28:22
Had to fabricate to fit my les Paul. Does not fit a Les Paul.
Recommended Products
$32.12
$ 14 .99 $14.99