Your cart is empty.
Your cart is empty.
Compatible with the following vehicles:
- Replacement for Honda Rebel 250 CMX250C 2012-2015, 1996-2009, 1985-1987
Features:
- Color: Black with Polish Clutch Lever
- Brake Connection: Two Prong
- Size: Piston Bore:14mm; Banjo Bolt: 10x1.25mm
- Outlet Location: Side Mount Outlet Facing Handlebar
Package includes:
- 1 x Brake Master Cylinder(Right Side)
R Dan Pauley
2025-08-18 17:11:54
Hard to believe they can be produced that inexpensive.
Roger Liu
2025-08-14 14:34:42
Bought this along with a new rotor, caliper, and brake line to improve the stopping power on my Razor dirt bike. So far my brakes have worked well.
Logan Macnamara
2025-08-09 16:33:45
2 Favorite things about it are that it looks very good and that the customer service is amazing. I got it to replace the bulky and shabby master cylinder on my 81 kawasaki. It looks very good and is much lower profile than the original but still has the same size master cylinder bore and banjo fitting. I has an issue while mounting it and request a replacement. Replacement arrived less than 48 hours later. Before I even had time to send back the first 1. I'm a fan. But customers do yourself a favor and sand the paint overspray off the inside of the reservoir with a piece of tape covering the bottom of the reservoir as to not contaminate the piston
Melbee
2025-07-31 09:14:57
The description said this front brake lever and reservoir is a fit for a Honda Rebel 250 but it is NOT! It fits but has no frigging mirror hole!! Because of time constraints I am forced to use this one temporarily but I ordered a proper fitting one WITH the mirror hole and will swap the Amazon one out when I get the proper one from EBay!
Michelle A.
2025-05-28 17:49:58
Good product for intended use. No complaints
Mandy
2025-03-29 17:58:29
I needed a replacement for my 1986 Honda Rebel 250. This is slimmer than the OG stock one, but works great!
Lil frost
2025-02-27 11:29:24
I got this product looks grate can't un screw the lid though the screws they put in was over tightened can't get them out without it stripping.
Phillip
2025-02-08 11:41:05
I had to send this item back because it had no mirror mount and said it fit a 1985 Honda rebel I don’t understand why the maker of this item wouldn’t think you would need your mirror mount🤔
Richard cloutier
2025-02-06 10:41:39
It takes forever to get fluid pumping. From a dry system so be patient and Don't stop pumping.
Recommended Products
