Your cart is empty.
Your cart is empty.Product Description
This CAMVATE Microphone Screw Adapter features a dimension of 5/8'' male to 1/4'' female, it comes with a bottom pedestal mount with 2 fitting holes, which allows this installation to support a microphone attached to the table podium, wall and ceiling.
Net Weight: 47.3 g
Package Included:
1 × 5/8''-27 Male to 1/4''-20 Female Microphone Screw Adapter
1 × Bottom Pedestal Mount With Fitting Holes
2 × TA5 Mounting Screw
ohio joe
August 30, 2025
I'm using this to make a low profile mic boom for my office. I'm going to attach it to the bottom of a wall mounted bookshelf that is above my computer monitor . . . I have and use many CAMVATE accessories in my office and studios.
Max Zelenin
August 26, 2025
worked great, prefect length!!
Sam Duke
June 28, 2025
Works well, but the knurl will slip once (its screwed in from the bottom) it’s installed and it must be removed to adjust the mic if it breaks loose
Mark Hazzard
May 20, 2025
It works great
CDS
May 18, 2025
I've bought a few of these types of things recently and they all seem to have the same problem. You mount it, you screw something onto it and then when you go to take it off, it just spins because the bolt holding the adapter on loosens in the back where you can can't get to it anymore to tighten it. This thing is absolutely worthless.
Ben Tan
December 11, 2024
Works and it's sturdy, but only worth it if you plan on leaving it in place. The screw on the back comes off easier than unscrewing the mic so if you want to move things around you'll have to entirely dismantle it
Joe
November 20, 2024
I had a specialized use for this. I have a wooden desk I built and needed a way to mount a Pixel Display (Divoom Pixoo-64) with a microphone adapter. This required some work because the Pixel monitor needed a special M6 Male Threaded Screw Adapter. So it works great, but short story sometimes doing something takes some trial and error. However, this became the best solution.
Recommended Products
$89.00
$ 34 .99 $34.99