Your cart is empty.
Your cart is empty.Neoprene boots designed with additional bellows where necessary, reduce stress and ozone cracking. Threads and splines are precision rolled for hassle-free replacement. 3 percent moly grease provides excellent high temperature characteristics for longer life and better wear. Transmission seal diameter is precision machined after heat treatment to ensure correct surface finish, promoting long seal life.
Customer
2025-08-12 11:09:25
working well so far the new boots are nice
Jacqulyn Clevenger
2025-07-23 13:38:51
I purchased this to replace current cv axel. The axel on my truck had been replaced close to hundred thousand miles ago and I noticed both boots were split and throwing grease, I got on Amazon and placed the order and had it installed, I believe it will be a fine part and work as it should, it was cheaper than orielys quoted me. This product is made in China but as long as it’s at OEM spec then I don’t see an issue and time only tells on longevity. I would buy without hesitation the part quality was good.
Robert Crandall
2025-03-11 14:26:18
I have replaced about 10 of these in the last 5 years on all makes, Ford, GM, Dodge etc.For all the technology these have gone through they are still an item that needs to be serviced.I like the Dodge design that both sides (LH and RH) are the same unit.The worst ones are the older ones that you need to get inside the axle to take the 'C' clip out but most of the newer ones are simply the yank-off versions. That said a lot of them are completely frozen to the splines and need to be hammered off.Some just don't have the room to get a hammer on and even then it can take 2-300 hits to get it off.I did see a video of a guy using the actual shaft as a slide hammer by:1) Cutting the boot off.2) Taking 3 vise grips and clamping near the end of the CV joint slide chamber.3) Yank the heck out of it. Still going to take as many hits but at least you are hitting even (straight out).When I put mine back together I grease the entire spline really well in case I do need to do this again.For the price I will stay with the Cardone brand if it's available and the price doesn't get crazy.
kyle gilpin
2025-03-01 11:51:23
great price great product
jamie
2025-02-28 11:14:37
Seems to be good sturdy rubber boots
Jose Morales
2024-12-27 12:33:21
Fits and works as advertised. No issues at all.
Master tech
2024-12-05 13:53:46
Easy install just like the originals would highly recommend Cardone parts
Noromdi Puts
2024-11-28 12:10:01
Fit well in my 2011 Dodge Ram 1500. Installed 3 months ago and still works fine.
Lonebear
2024-11-15 15:43:31
Bought for my 2010 ram dealer price was 400 I bought two for under 300 and fits
Recommended Products
$69.99
$ 32 .99 $32.99
$75.06
$ 32 .99 $32.99