Your cart is empty.
Your cart is empty.Disc Brake Caliper Guide Pin Boot Kit. Direct replacement
Jason Porter
August 29, 2025
290,000 miles this is the first time I've needed to do any repair with the front calipers. After praying out the holes where the pins go, little use with a Q tip, I reassembled with some brake fluid to make sure parts moved freely. Simple perfect repair with Detroit axle pad/rotor kit. Satisfying simple job.
Matthew C.
August 27, 2025
Perfect. It fit my 2002 Honda Civic. And is identical the the original rubber fitting. One may think the end of the fitting that is supposed to sit inside the caliper is difficult, but all you need to do is squish it and force it in, and it will “pop into place†after you try a few times. You can’t hurt the rubber and you’ll know when it’s in. I also use silicone grease instead of other petroleum grease. Putting some extra on helps get it in.
Frenchyaz
August 8, 2025
I got these to replaced mine on my car. They seemed a bit smaller than the ones I had but by not much. They are made in China however for the price they seem sturdy and well made.You get 2 boots for each caliper sliders and 2 bushings. On my car, it seems like the little bushings go on the top slider Pin. You have one on each side of the car.Make sure remove the goo from the former lubricant and lubricate well the pin with either Silicone Paste or Silicon compound. If you use petroleum lubricant, you will eat the rubber and you will have to do the job again.Best lubricants for these are either Jet-Lube Silicone DM Dielectric (operating temperature -70-400F, flash point 500F) or 3M 08946 Clear Silicone Paste (same operating temperature but flash point 570F). They are both dielectric too so you can apply them pretty much everywhere.
Customer
August 1, 2025
So far these are working fine. Easy to install although they are a bit thicker than the originals. Time will tell
Commuter Ben
July 11, 2025
I replaced the set on my 2016 Honda Fit LX. They are a perfect fit!
R W Woods
July 8, 2025
They keep the grease in as they’re supposed to pages fit a little larger than the bolt
Ed A
June 14, 2025
Haven’t installed yet but great price
Andrew T.
June 3, 2025
Always count on Carlson hardware kits.
Mr. Le
May 16, 2025
A bit tricky to install but overall good replacement for my caliper pin boots. These help prevent corrosion from moisture and contaminates getting in.
NIC
February 23, 2025
used in Honda CRV
Jose Alvarado
February 5, 2025
Quedaron ala medida
Yoichi
January 2, 2025
Excelente calidad 👌 perfecto Civic 2009
Ismael
December 13, 2024
Cest super ca marche tres bien. Tres bonne product. Je vous recommends forte meant
Recommended Products
