Your cart is empty.
Your cart is empty.Product Description
JB
July 23, 2025
Worked well fit as advertised, well made looks great 95 k3500
Corey Johnson
June 22, 2025
The thing looks beautiful but the holes don’t exactly match so I had to use zip ties because I couldn’t get screws to go thru. But other than the holes not adding up I finally got it close enough to make it look good. Hopefully other people will have a better experience than I did
gary9891
June 18, 2025
Overall dimensions are good, fits under the bumper spot on. The issue are the holes in the valence (alignment) to the factory holes in the bottom of the bumper. There are about 10 holes and 4 are a tough fit. 6 of the 10 fit, but 4 screws are off a bit and had to go in at an slight angle. Once tightened, the 4 screws did straighten up a bit. From the outside, all looks fine. Alignment with the factory tow hooks look ok as well if you have them (I did not have). Overall, pleased for the results vs. the cost. I did not use the factory screws from my old valence remains, just too corroded. I used some 10-32x 3/4 with washers and ny-lock nuts.
Customer
June 7, 2025
Granted, this may not come with hardware, it is as simple as 10 S/S bolts, washers and lock nuts and you are in business. The holes for the tow hooks do look a little crude from the back side, as you can see, it looks great/factory when installed, its a $40 part that looks like $200, this IS NOT hard to install at allFor the money = GREAT PRODUCT
Matt
May 12, 2025
This Is junk. It does not fit. it is about an inch short on ends. the holes don't line up, the mounting flange is bent and makes putting in fasteners extremely difficult, that is after you drilled some new holes for fasteners because they don't line up to the bumper. There is horrible casting lines where plugs for tow hook and light holes were. Do Not buy, you will have much better luck finding something that fits and looks better from a junk yard.
JOSEPH SACK
April 17, 2025
Good product, a little tight on width but managed to stretch all the way across.
Charles C. Caporiccio
April 16, 2025
the edge where the piece attaches to the bumper is warped and the holes do not align well. I could not use the original clamp pieces except at the ends. I had to us bolts and tighten a nut down to get the dam to pull towards the bumper holes and out of the seven attachments, was able to get 5 . What should have been a fifteen minute exercise turned out to take me several hours. Old truck so it looks fine and will stay in place and did not want to hassle with a return. Just could have, should have, been easier to attach.
Sprucegreen14
April 12, 2025
Looks and fits great installed in minutes with no cutting or drilling
goran 007
February 13, 2025
Fit perfect on my '98 CHEVY C1500
Recommended Products
$16.98
$ 6 .99 $6.99