Your cart is empty.
Your cart is empty.Replacement Lower Auger Bearing for Serenity Pellet Stoves. The bottom bearing is located underneath the circular plate and is held in place by a snap ring (You will need needle-nose or snap-ring pliers to fully remove this ring). When reassembling, ensure that the bearings are in place and do not bind up when the auger shaft is spun. The bearing should glide around freely with little resistance but should not “whizz” around like a skate wheel when spun. - Compatible with the Castle HPS09, Castle HPS10, Castle HPS10IC, Castle Serenity Outer Diameter:1 1/2",Inner Diameter:13/16"
J. Borge
2024-12-31 15:49:20
Stove was making a squeaky/squealing noise while feeding. Ordered the 2 bearings, and a new washer. Once installed…NO MORE NOISE!! Thank you very much for the quick shipping too (arrived in 48 hrs).
Recommended Products
