Your cart is empty.
Your cart is empty.Product Description
Tracy borden
2025-09-03 12:31:29
Good
Angeleyes
2025-09-02 17:22:12
These were falling apart as you install them. They don’t fit in the hole where the bulb comes in. They fit so loose that they don’t light up. Don’t waste your time and money on these.
John
2025-04-04 09:51:22
These were listed as fitting in a 2007 Hummer H3 but they do not fit as is.The base does match the existing center console panel lights but the LEDs are actually wider than the base that has to fit through the circuit board hole.I needed to sand down the LED on 2 sides to get it to fit through the hole, after that then all worked good.
Collins Njoku
2025-03-15 18:24:14
These were falling apart as you installed them. They don’t fit in the hole where the bulb comes in. Don’t waste your time and money on these.
Avi
2025-03-06 15:52:21
Lights are bright however depending on the application it needs to be modified to fit properly.
Jeff Homan
2025-02-12 11:18:55
Looks a little more purple but could be due to the plastic material that it has to shine through.Had to take a little off the white board to fit in the hole
Kathy
2025-02-01 11:05:34
The product works as intended. But are very fragile and brake easily. Only half of the LEDs are useable cause most snapped thenplastic housing, and a few of the LEDs jsut ripped off the pedestal. So its ok but not great quality.
Thomas R
2024-11-24 11:29:13
If the bulb does not fit easily the first time for your car I wouldn't even try to make it work unless you are knowledgeable of led lights and are willing to manipulate it to work. I had to extend the bulb just to fit into the hole then the plastic twist on clip did not even reach the edges to twist on. You will have to try to pry the edges up without damaging the bulb in order to make them high enough to twist on. If you manage to do all that the lights are not to terribly bad they are pretty bright
Recommended Products